Hitachi CP-S420/CP-X430 Operations, Power on, Power OFF, Standby, Equipment is used safely

OPERATIONS

	STANDBY/	STANDBY/ON	BLANK
STANDBY/ON Button	ON Button		LASER

ENGLISH

POWER Indicator

VIDEORGB

	Zoom Knob
	Focus Ring	AUTO
		MENU	KEYSTONE
		MENU SELECT
		POSITION	RESET
Power Switch		FREEZE	PinP
		MAGNIFY	MUTE
		OFF

Lens Cap

Power ON

1.Check that the power cord is connected correctly.

2.Set the power switch to [ ]. The standby mode is selected, and the POWER indicator is turned to orange.

3.Press the STANDBY/ON button on the control panel or the remote control transmitter. Warm-up begins and the POWER indicator blinks in green.

4.The POWER indicator ceases blinking and turns to green when power is on. Remove the lens cap.

5.Adjust picture size using the zoom knob.

6.Adjust focus using the focus ring .

Power OFF

1.Press the STANDBY/ON button on the control panel or the remote controller. Then,the message "Power off?" will appear on the screen, and the message will disappear by any operation

or no operation for 5 seconds. During this message indication, press the STANDBY/ON button again. The projector lamp is extinguished and lamp cooling begins. The POWER indicator

blinks orange during lamp cooling. Pressing the STANDBY/ON button has no effect while the POWER indicator is blinking.

2.The system assumes the Standby mode when cooling is complete, and the POWER indicator ceases blinking and changes to orange. Check that the indicator is orange and set the power switch to [O].

3.The POWER indicator is extinguished when power is off. Do not forget to attach the lens cap.

WARNING • Please read this manual, and the separate “SAFETY INSTRUCTIONS” thoroughly before using the equipment. Always ensure that

the equipment is used safely.

NOTE • Except in emergencies, follow the above-mentioned procedure for turning power off. If the projector is used improperly, it may very difficult to turn off the projector caused by heating inside the unit. And the reduction of life time of lamp and LCD panels will be caused by incorrect procedure.

•To prevent any trouble, turn on/off the projector when the computer or video tape recorder is OFF. Providing a RS-232C cable is connected, turn on the computer before the projector.

•When a projector continues projecting the same image, the image may remain as an afterimage. Please do not project the image same for a long time.

ENGLISH-9

Downloaded from www.Manualslib.com manuals search engine