Connection to the control signal terminal
1. Control signal terminal
. |
|
| Mouse |
| |
Pin No | RS232C |
|
|
| |
PS/2 | ADB | Serial | |||
|
| ||||
|
|
|
|
| |
1 |
|
|
|
| |
|
|
|
|
| |
2 |
| CLK | DATA |
| |
|
|
|
|
| |
3 |
| DATA |
|
| |
|
|
|
|
| |
4 |
|
|
|
| |
|
|
|
|
| |
5 |
|
|
|
| |
|
|
|
|
| |
6 | SELO | SEL0 |
| SEL0 | |
|
|
|
|
| |
7 | RTS | RTS | RTS | RTS | |
|
|
|
|
| |
8 |
|
|
|
| |
|
|
|
|
| |
9 |
| +5V | +5V |
| |
|
|
|
|
| |
10 | GND | GND | GND | GND | |
|
|
|
|
| |
11 |
|
|
|
| |
|
|
|
|
| |
12 |
|
|
|
| |
|
|
|
|
| |
13 | RDP |
|
|
| |
|
|
|
|
| |
14 | TDP |
|
| TD | |
|
|
|
|
| |
15 |
|
|
|
| |
|
|
|
|
|
Caution Turn off the power of both the projector and computer before connecting.
Connectthecomputertothecontrolterminaloftheprojectorusinganappropriatecable.
Refer to the instruction manual of each device before connecting.
2.Mouse emulation
(1)Connect the projector and the mouse terminal of computer using an appropriate cable, while the projector and the computer are turn off because mouse emulation don’t work.
(2)Turn on the projector (The ON indicator will light up orange.).
(3)Press the INPUT of the projector or RGB 1/2 button of the remote control transmitter and select the input connection.
(4)Turnonthecomputer.
(5)Startmouseemulationmode.
If can not start mouse emulation, reset the computer. (With soft reset or reset switch)
(6)See on the page 9 about to operate the remote control transmitter.
(7)Operation speed of the mouse will vary according to the pressing force on the DISK PAD button.
Caution • In some note computers which have internal pointing device, mouse emulation don’t work without setting the internal pointing device disabled. In this case, set the internal pointing device disabled in BIOS setting. After setting in BIOS, operate (1) ~ (5) Please check its hardware manuals to disable internal pointing device in BIOS setting.
•In some computers, mouse emulation don’t work without the utility program. In this case, see andchecktheoperatingmanualsofthecomputer.
22
