OPERATIONS (continued)
No Signal Menu
The same adjustments and settings are available with the Image and Options menus when the MENU button is pressed during display of the “NO INPUT IS DETECTED ON ***” or “SYNC IS OUT OF RANGE ON ***” message while no signal is received.
Table 8. No Signal Menu
VOLUME
BLANK
MIRROR
START UP 
MENU COLOR 
LANGUAGE 
AUTO OFF 
SYNC ON G 
WHISPER
16
ENGLISH
Item | Description |
Volume Adjustment: Reduce VOLUME 
↔ Increase VOLUME
•When this function is used, audio input is automatically switched to video. The
VOLUME | audio input can be switched by moving the DISK PAD left and right during the |
| display of the volume adjustment bar. The volume adjustment bar is displayed by |
| pressing VOLUME or VOLUME button. |
| Select Blank Screen Color: Select the color with the | and | buttons. | |
BLANK | •The image is cleared and the entire screen is displayed in the selected color, | |||
when BLANK mode is set with BLANK ON, or when there is no signal for 5 | ||||
| ||||
| minutes. |
|
| |
|
|
|
| |
MIRROR | Operation Start/Stop: Press the / button. |
|
| |
Select Mirror Status: Select the mirror status with the | and | buttons. | ||
| ||||
|
|
|
| |
| Operation Start/Stop: Press the / button. |
| |
START UP | Setup Initial Screen Display: Select the TURN ON with the | button. | |
Clear Initial Screen Display: Select the TURN OFF with the | button. | ||
|
•Note that if TURN OFF is selected the blank screen is displayed in blue when there is no signal.
MENU COLOR Select Menu Background Color: Select the color with the 
and 
buttons.
Operation Start/Stop: Press the 
/ 
button.
LANGUAGE Select Menu Display Language: Select the language with the 
and 
buttons.
| Operation start/stop: Press the / button. |
|
| Set AUTO OFF: Set 1~99 minutes with the and | buttons. The |
AUTO OFF | system automatically enters the standby mode when a signal is not | |
received for the set time. |
| |
| Clear AUTO OFF: Select the STOP (0 min.) with the | button. When |
| the STOP is selected the system does not enter the standby mode even | |
| if no signal is received. |
|
|
|
|
Operation Start/Stop: Press the 
/ 
button.
SYNC ON G Valid: Select the TURN ON with the 
button. SYNC ON G SYNC ON G Invalid: Select the TURN OFF with the 
button.
•May not be displayed correctly with some input signals when the SYNC ON G is valid. In such cases, remove the signal connector so that no signal is received, set the SYNC ON G to invalid, and reconnect the signal.
Operation Start/Stop: Press the 
/ 
button.
WHISPER | Set/Clear Wisper Mode: Press / button. When the WHISPER is |
selected, the WHISPER mode is active. In the WHISPER mode, | |
| acoustic noise level from the unit is reduced, brightness level on screen |
| is a little lower. |
