English
ASSEMBLY AND OPERATION
APPLICATIONS
Cutting metal and stainless steel pipe.
Cutting various lumber.
Cutting mild steel, aluminum and copper plate.
Cutting synthetic resins, such as phenol resin and vinyl chloride.
REMOVAL AND INSTALLATION METHOD OF BATTERY
How to install the battery.
Align the battery with the groove in tool handle and slip it into place.
Always insert it all the way until it locks in place with a little click, If not, it may accidentally fall out of the tool, causing injury to you or someone around you (Fig. 3).
How to remove the battery.
Withdraw battery from the tool handle while pressing the latch (2 pcs) of the battery (Fig. 3).
| Insert |
Pull out | Handle |
| |
| Latch |
| Push |
| Battery |
Fig. 3
CHARGING METHOD
NOTE:
Before plugging into the receptacle, make sure the following points.
The power source voltage is stated on the nameplate.
The cord is not damaged.
WARNING:
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the charger will burn out.
1.Connect the charger’s power cord to a receptacle. When the power cord is connected, the charger’s pilot lamp will blink in red. (At
WARNING:
Do not use the electrical cord if damaged. Have it repaired immediately.
2.Insert the battery into the battery charger. <UC18YRSL>
Firmly insert the battery into the battery charger until the line is visible, as shown in Fig. 4 .
Battery
Pilot lamp
Charger
Line
Line
<BSL1430><BSL1830>
Fig. 4
<UC18YGSL>
Insert the battery into the battery charger as shown in Fig. 5. Make sure it contacts the bottom of the battery charger.
BSL1415X BSL1815X
Fig. 5
11