English
ASSEMBLY AND OPERATION
APPLICATIONS
Cutting metal and stainless steel pipe.
Cutting various lumber.
Cutting mild steel, aluminum and copper plate.
Cutting synthetic resins, such as phenol resin and vinyl chloride.
REMOVAL AND INSTALLATION METHOD OF BATTERY
CAUTION: Be sure to keep the switch turned off and the
Handle | Switch trigger |
Latch
Insert
Battery
Pull out
Push
Fig. 5
How to install the battery.
Align the battery with the groove in tool handle and slip it into place.
Always insert it all the way until it locks in place with a little click. If not, it may acci- dentally fall out of the tool, causing injury to you or someone around you. (Fig. 5)
How to remove the battery.
Withdraw battery from the tool handle while pressing the latches (2 pcs.) on the sides of the battery. (Fig. 5)
CHARGING METHOD
The following is an explanation of charging methods when using the battery charger US24YFA, UC24YJ or UC18YG.
NOTE: Before plugging into the receptacle, make sure the following points.
The power source voltage is stated on the nameplate.
The cord is not damaged.
WARNING: Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the charger will burn out.
14
