English
〈UC18YG〉
NOTE: Before plugging into the receptacle, make sure the following points.
The power source voltage is stated on the nameplate.
The cord is not damaged.
WARNING: Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the charger will burn up.
1. Insert the plug of battery charger into the receptacle
WARNING: Do not use the electrical cord if damaged. Have it repaired immediately.
2. Insert the battery to the battery charger | Battery |
Insert the battery into the battery charger as |
|
shown in Fig. 8. Make sure it contacts the bot- |
|
tom of the battery charger. |
|
Pilot lamp
Fig. 8
3. Charging
When the battery is connected to the battery charger, charging will commence and the pilot lamp will light on.
NOTE: If the pilot lamp dose not light, pull out the plug from the receptacle and check if the battery is properly mounted.
In approx. 60 min., when the battery is fully charged, the pilot lamp will go out.
NOTE: The battery charging time becomes longer when a temperature is low or the voltage of the power source is too low.
When the pilot lamp does not go off even if more than four hour has passed after start of the charging, stop the charging and contact your HITACHI AUTHORIZED SERVICE
20
