English

Arrow

Fig. 16

Hook main body

Protube-

Inden- rance tation

AAAA

Protube-

rance

batteries

Indentation Hook cover

 

Fig. 17

NOTE:

Do not tighten the screw excessively. Such action could strip the screw threads.

CAUTION:

Failure to observe the following can result in battery leakage, rust or malfunction.

Position the plus (+) and minus (–) terminals correctly.

Replace both batteries at the same time. Do not mix old and new batteries.

Remove exhausted batteries from the hook immediately.

Do not discard batteries together with normal trash and do not throw batteries into fire.

Store batteries out of the reach of children.

Use batteries correctly in accordance with the battery specifications and indications.

2.Switch operation

When the switch trigger is depressed, the tool rotates.Whentheswitchtriggerisreleased,thetool stops.

The rotational speed of the rotary hammer can be controlled by varying the amount that the switch trigger is pulled. Speed is low when the switch trigger is pulled slightly and increases as the switch trigger is pulled more.

When releasing the switch trigger, the brake will be applied for immediate stopping.

3.Rotation + Hammering

Turn the change lever fully in the direction of the “” mark to set “rotation + hammering”. (Fig. 18)

“” mark

Change lever

“” mark

Fig. 18

(1)Mount the drill bit.

(2)Pull the trigger switch after applying the drill bit tip to the drilling position. (Fig. 19)

Fig. 19

(3)Pushingtherotaryhammerforciblyisnotnecessary at all. Pushing slightly so that drill dust comes out gradually is just sufficient.

CAUTION:

When the drill bit touches construction iron bar, the bit will stop immediately and the rotary hammer will react to revolve. Therefore please grip the side handle and handle tightly as shown in Fig. 19.

4.Rotation only

Turn the change lever fully in the direction of the “” mark to set “rotation only”. (Fig. 18)

To drill a wood or metal material using the optional drill chuck and chuck adapter, proceed as follows. Installing drill chuck and chuck adapter : (Fig. 20)

(1)Attach the drill chuck to the chuck adaptor.

(2)The part of the SDS-plus shank is the same as the drill bit. Therefore, refer to the item of “Mounting the drill bit” for attaching it.

Drill chuck

Front

cap Grip

Chuck adapter

Part of SDS-plus shank

Fig. 20

16