drill bits which have
mm) overall length.
◯Dump particles after every two or three holes when drilling.
◯Please replace the drill bit after removing dust collector (B).
8. Selecting the driver bit
Screw heads or bits will be damaged unless a bit appropriate for the screw di- ameter is employed to drive in the screws.
9. Confirm the direction of bit ro-
tation (Fig. 5)
Lever
The bit rotates clockwise (viewed from the rear side) by pushing the
counterclockwise.
HOW TO USE
CAUTION:
Fig. 5
◯To prevent accidents, make sure to turn the switch off and disconnect the plug from the receptacle when the drill bits and other various parts are installed or removed. The power switch should also be turned off during a work break and after work.
1.Switch operation
The rotation speed of the drill bit can be controlled steplessly by varying the amount that the trigger switch is pulled. Speed is low when the trigger switch is pulled slightly and increases as the switch is pulled more. To turn the switch OFF, release the trigger switch to its original position.
2.Rotation + Striking
This rotary hammer can be set to rota- tion and striking mode by turning the change lever fully counterclockwise to
mark. (Fig. 6)
(1)Mount the drill bit.
(2)Pull the trigger switch after applying the drill bit tip to the drilling position (Fig. 7)
(3)Pushing the rotary hammer forcibly is not necessary at all. Pushing slightly so that drill dust comes out gradually is just sufficient.
Change Lever
Fig. 6
Fig. 7
12
