English
ASSEMBLY AND OPERATION
APPLICATIONS
Use as a drill
Drilling of soft steel, wood, plastic and aluminum materials.
Use as a screwdriver
Tightening and loosening of machine screws, wood screws and tapping screws.
REMOVAL AND INSTALLATION METHOD OF BATTERY
1.Battery removal
Hold the handle tightly and push the battery latch to remove the battery (See Fig. 3).
CAUTION
Never
2.Battery installation
Insert the battery while observing its polarities (see Fig. 3).
Handle
Insert 
Latch
Pull out
Battery push
Fig. 3
CHARGING METHOD
NOTE:
Before plugging into the receptacle, make sure the following points.
The power source voltage is stated on the nameplate.
The cord is not damaged.
WARNING:
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the charger will burn up.
1.Connect the charger’s power cord to a receptacle. When the power cord is connected, the charger’s pilot lamp will blink in red. (At
WARNING:
Do not use the electrical cord if damaged. Have it repaired immediately.
2.Insert the battery into the charger.
Firmly insert the battery into the charger as shown in Fig. 4 .
BSL1415X
BSL1815X
Fig. 4
3.Charging
When the battery is connected to the battery charger, charging will commence and the pilot lamp will light in red. (See Table 2)
NOTE:
If the pilot lamp flikers in red, pull out the plug from the receptacle and check if the battery is properly mounted.
When the battery is fully charged, the pilot lamp will blink in red slowly. (At
11