English
When carrying the power tool with hooked to your waist belt, do not fit any bit to the tip of power tool. If the sharp bit such as drill is fitted to the power tool when carrying it with hooked to your waist belt, you will be injured.
Install securely the hook. Unless the hook is securely installed, it may cause an injury while using.
(1)Removing the hook.
Remove the screws fixing the hook with Philips screw driver. (Fig. 10)
Screw
Hook
Fig. 10
(2)Replacing the hook and tightening the screws. Install securely the hook in the groove of power tool and tighten the screws to fix the hook firmly. (Fig. 11)
Screw
Hook
Fig. 11
11.Using the light
Pull the trigger switch to light up the light. The light keeps on lighting while the trigger switch is being pulled. The light goes out after releasing the trigger switch. (Fig. 12)
Light 
Trigger switch
Fig. 12
CAUTION:
Do not look directly into the light. Such actions could result in eye injury.
12.The scope and suggestions for uses
The usable scope for various types of work based on the mechanical structure of this unit is shown in Table 5.
Table 5
| Work | Clutch dial position | Suggestions | |
|
|
|
|
|
|
| Wood |
|
|
|
|
|
|
|
Drilling |
| Steel |
| Use for drilling purpose. |
|
|
|
|
|
|
| Aluminum |
|
|
|
|
|
|
|
|
| Small | 1 – 22 | Use the bit and socket matching the screw |
Screw |
| screw | diameter. | |
|
| |||
tightening |
| Wood | 1 – | Use after drilling a pilot hole. |
|
| screw | ||
|
|
|
| |
|
|
|
|
|
15