English

How to make the batteries perform longer.

Recharge the batteries before they become completely exhausted.

When you feel that the power of the tool becomes weaker, stop using the tool and recharge its battery. If you continue to use the tool and exhaust the electric current, the battery may be damaged and its life will become shorter.

Avoid recharging at high temperatures.

A rechargeable battery will be hot immediately after use. If such a battery is recharged immediately after use, its internal chemical substance will deteriorate, and the battery life will be shortened. Leave the battery and recharge it after it has cooled for a while.

BEFORE USE

Check the work area to make sure that it is clear of debris and clutter.

Clear the area of unnecessary personnel. Ensure that lighting and ventilation is adequate.

OPERATION

1.Mounting and dismounting of the bit.

(1)Mounting the bit.

Insert a screwdriver bit etc. into the keyless drill chuck.

Firmly grasp the ring and tighten the sleeve by turning it toward the right (in the clockwise direction as viewed from the front) (See Fig. 5).

NOTE:

Loosening stuck or hard to move sleeves.

Grasp the bit installed in the keyless chuck, in a vise or similar tool.

Set the clutch dial position to “1-11” and turn on the switch. The motor then starts.

Finally, rotate the sleeve to the left, and it will loosen.

2.Confirm that the battery is mounted correctly.

3.Check the rotational direction.

The bit rotates clockwise (viewed from the rear side) by pushing the R-side of the selector button. The L-side of the selector button is pushed to turn the bit counterclockwise (See Fig. 6). (The L and R marks are provided on the body.)

Trigger

Selector

switch

button

R marks

L marks

Fig. 6

 When the trigger switch is depressed, the tool

rotates. When the trigger is released, the tool stops.

Ring Sleeve

Tighten

Loosen



The rotational speed of the drill can be controlled

 

by varying the amount that the trigger switch is

 

pulled. Speed is low when the trigger switch is

 

pulled slightly and increases as the trigger switch

 

is pulled more.



When releasing the trigger of the switch, the brake

 

will be applied for immediate stopping.

4.

Change rotation speed.

Fig. 5

NOTE:

If the sleeve becomes loose during operation, tighten it further.

The tightening force becomes stronger when the sleeve is tightened.

(2)Dismounting the bit

Firmly grasp the ring and loosen the sleeve by turning it toward the left (in the counterclockwise direction as viewed from the front) (See Fig. 5).

CAUTION:

When mounting a bit into the keyless chuck, tighten firmly. If the sleeve is not tight, the bit may slip or fall out, causing injury.

High speed

Shift knob

Fig. 7

Lowspeed

Shift knob

Fig. 8

15