English
CAUTION:
●The motor rotation may be locked to cease while the unit is used as drill. While operating the driver drill, take care not to lock the motor.
●When setting the shift knob to “HIGH” (high speed) and the position of the clutch dial is “17” to “22”, it may happen that the clutch does not engaged and that the motor is locked. In such a case, please set the shift knob to “LOW” (low speed).
●If the motor is locked, immediately turn the power off. If the motor is locked for a while, the motor or battery may be burnt.
●Too long hammering may cause the screw broken due to excessive tightening.
●A buzzing noise is produced when the motor is about to rotate; This is only a noise, not a machine failure.
7.Using the hook
The hook is used to hang up the power tool to your waist belt while working.
CAUTION
●When using the hook, hang up the power tool firmly not to drop accidentally.
If the power tool is dropped, it may lead to an accident.
●When carrying the power tool with hooked to your waist belt, do not fit any bit to the tip of power tool. If the sharp bit such as drill is fitted to the power tool when carrying it with hooked to your waist belt, you will be injured.
●Install securely the hook. Unless the hook is securely installed, it may cause an injury while using.
(1)Removing the hook.
Remove the screws fixing the hook with Philips screw driver. (Fig. 11)
(2)Replacing the hook and tightening the screws. Install securely the hook in the groove of power tool and tighten the screws to fix the hook firmly. (Fig. 12)
Groove
Screw
Hook
Fig. 12
Hook Screw
Fig. 11
17