English

ASSEMBLY AND OPERATION

APPLICATIONS

Drilling of brick and concrete block, etc.

Driving and removing of machine screws, wood screws, tapping screws, etc.

Drilling of various metals

Drilling of various woods

REMOVAL AND INSTALLATION METHOD OF BATTERY

1.Battery removal

Hold the handle tightly and push the battery latch to remove the battery (See Fig. 3).

CAUTION

Never short-circuit the battery.

2.Battery installation

Insert the battery while observing its polarities (See Fig. 3).

Handle

Insert

Pull out

Latch

 

Battery Push

Fig. 3

CHARGING METHOD

NOTE:

Before plugging into the receptacle, make sure the following points.

The power source voltage is stated on the nameplate.

The cord is not damaged.

WARNING:

Do not charge at voltage higher than indicated on the nameplate.

If charged at voltage higher than indicated on the nameplate, the charger will burn up.

1.Connect the charger’s power cord to a receptacle. When the power cord is connected, the charger’s pilot lamp will blink in red. (At 1-second intervals)

WARNING:

Do not use the electrical cord if damaged. Have it repaired immediately.

2.Insert the battery to the battery charger.

Firmly insert the battery into the charger as shown in Fig. 4.

BSL1415 BSL1815

Fig. 4

3.Charging

When the battery is connected to the battery charger, charging will commence and the pilot lamp will light in red. (See Table 2)

NOTE:

If the pilot lamp flikers in red, pull out the plug from the receptacle and check if the battery is properly mounted.

When the battery is fully charged, the pilot lamp will blink in red slowly. (At 1-second intervals) (See Table 2)

(1)Pilot lamp indication

The indications of the pilot lamp will be as shown in Table 2, according to the condition of the charger or the rechargeable battery.

12