English

The L-side of the selector button is pushed to turn the bit counterclockwise (See Fig. 10). (The L and

Rmarks are provided on the selector button.)

Trigger switch

Selector button

Fig. 10

CAUTION

Always use this unit with clockwise rotation, when using it as an impact drill.

10. Switch operation

When the trigger switch is depressed, the tool rotates. When the trigger is released, the tool stops.

The rotational speed of the drill can be controlled by varying the amount that the trigger switch is pulled. Speed is low when the trigger switch is pulled slightly and increases as the trigger switch is pulled more.

NOTE:

A buzzing noise is produced when the motor is about to rotate. This is only a noise, not a machine failure.

11.For drilling into brick

Excessive pressing force never increases drilling speed. It will not only damage the drill tip or reduce working efficiency, but could also shorten the service life of drill bit. Operate the hammer drill within 10-15 kg pressing force while drilling into brick.

12.Using the hook

The hook is used to hang up the power tool to your waist belt while working.

CAUTION

●When using the hook, hang up the power tool firmly not to drop accidentally.

If the power tool is dropped, it may lead to an accident.

●When carrying the power tool with hooked to your waist belt, do not fit any bit to the tip of power tool. If the sharp bit such as drill is fitted to the power tool when carrying it with hooked to your waist belt, you will be injured.

●Install securely the hook. Unless the hook is securely installed, it may cause an injury while using.

(1)Removing the hook.

Remove the screws fixing the hook with Philips screw driver. (Fig. 11)

HookScrew

Fig. 11

(2)Replacing the hook and tightening the screws. Install securely the hook in the groove of power tool and tighten the screws to fix the hook firmly. (Fig. 12)

Groove

Screw

Hook

Fig. 12

17