Hitachi ED-X32 Clean the projector or replace the lamp yourself, Damaging the lamp, During use

Lamp

WARNING

HIGH VOLTAGE HIGH TEMPERATURE HIGH PRESSURE

The projector uses a high-pressure mercury glass lamp. The lamp can break with a loud bang, or burn out, if jolted or scratched, handled while hot, or worn over time. Note that each lamp has a different lifetime, and some may burst or burn out soon after you start using them. In addition, when the bulb bursts, it is possible for shards of glass to fly into the lamp housing, and for gas containing mercury to escape from the projector’s vent holes.

About disposal of a lamp • This product contains a mercury lamp; do not put in trash. Dispose of in accord with environmental laws.

For lamp recycling, go to www.lamprecycle.org. (in USA)

For product disposal, contact your local government agency or www.eiae.org (in the US) or www.epsc.ca (in Canada).

For more information, call your dealer.

	• If the lamp should break (it will make a loud bang when it does), unplug
	the power cord from the outlet, and make sure to request a replacement
	lamp from your local dealer. Note that shards of glass could damage the
	projector’s internals, or cause injury during handling, so please do not try to
	clean the projector or replace the lamp yourself.
	• If the lamp should break (it will make a loud bang when it does), ventilate
Disconnect	the room well, and make sure not to breathe the gas that comes out of the
the plug from	projector vents, or get it in your eyes or mouth.
the power
outlet	• Before replacing the lamp, make sure the power switch is off and the
	power cable is not plugged in, then wait at least 45 minutes for the lamp to
	cool sufficiently. Handling the lamp while hot can cause burns, as well as
	damaging the lamp.
	• Do not open the lamp cover while the projector is suspended from above.
	This is dangerous, since if the lamp’s bulb has broken, the shards will
	fall out when the cover is opened. In addition, working in high places is
	dangerous, so ask your local dealer to have the lamp replaced even if the
	bulb is not broken.
	• Do not use the projector with the lamp cover removed. At the lamp
	replacing, make sure that the screws are screwed in firmly. Loose screws
	could result in damage or injury.
	• Use the lamp of the specified type only.
	• If the lamp breaks soon after the first time it is used, it is possible that
	there are electrical problems elsewhere besides the lamp. If this happens,
	contact your local dealer or a service representative.
	• Handle with care: jolting or scratching could cause the lamp bulb to burst
	during use.
	• Using the lamp for long periods of time, could cause it dark, not to light up
	or to burst. When the pictures appear dark, or when the color tone is poor,
	please replace the lamp as soon as possible. Do not use old (used) lamps;
	this is a cause of breakage.

8