Hitachi CP-A100W, EDA100 user manual Be careful in handling the light source lamp

Safety Precautions (continued)

WARNING

Be careful in handling the light source lamp.

The projector uses a high-pressure mercury glass lamp made of glass. The lamp can break with a loud bang, or burn out. When the bulb bursts, it is possible for shards of glass to fly into the lamp housing, and for gas containing mercury to escape from the projector’s vent holes.

Please carefully read the section “Lamp”.

Be careful in handling the power cord and external connection cables.

If you keep using a damaged the power cord or cables, it can cause a fire or electrical shock. Do not apply too much heat, pressure or tension to the power cord and cables.

If the power cord or cables is damaged (exposed or broken core wires, etc.), contact your dealer.

•Do not place the projector or heavy objects on the power cord and cables. Also, do not place a spread, cover, etc, over them because this could result in the inadvertent placing of heavy objects on the concealed power cord or cables.

•Do not pull the power cord and cables. When connecting and disconnecting the power cord or cables, do it with your hand holding the plug or connector.

•Do not place the cord near the heater.

•Avoid bending the power cord sharply.

•Do not attempt to work on the power cord.

Be careful in handling the battery of the remote control.

Incorrect handling of the battery could result in fire or personal injury. The battery may explode if not handled properly.

•Keep the battery away from children and pets. If swallowed consult a physician immediately for emergency treatment.

•Do not allow the battery in a fire or water.

•Avoid fire or high-temperature environment.

•Do not hold the battery with the metallic tweezers.

•Keep the battery in a dark, cool and dry play.

•Do not short circuit the battery.

•Do not recharge, disassemble or solder the battery.

•Do not give the battery a physical impact.

•Use only the battery specified in the other manual of this projector.

•Make sure the plus and minus terminals are correctly aligned when loading the battery.

•If you observe a leakage of the battery, wipe out the flower and then replace the battery. If the flower adheres your body or clothes, rinse well with water.

•Obey the local laws on disposing the battery.

SG4