English
MAINTENANCE AND INSPECTION
WARNING: Be sure to switch power OFF and disconnect the plug from the receptacle during maintenance and inspection.
Using cracked, deformed or damaged wheels can lead to wheel breakage and resulting serious injury.
1.Replacing the depressed center wheel
Replace the depressed center wheel when it has been worn out to about
2.Inspecting the screws
Regularly inspect all screws and ensure that they are fully tightened. Should any of the screws be loosened, retighten them immediately.
WARNING: Using this grinder with loosened screws is extremely dangerous.
3.Confirm that there is no damage in the wheel guard, the electrical cord and the housing, etc.
Check that the on/off switch operates normally.
4.Inspecting the carbon brushes (Fig. 6)
The motor employs carbon brushes which are consumable parts. Replace the carbon brush with a new one when it becomes worn to its wear limit. Always keep carbon brushes clean and ensure that they slide freely within the brush holders.
CAUTION:
●Using this grinder with a carbon brush which is worn in excess of the wear limit will damage the motor.
NOTE: Use HITACHI carbon brush No. 61 indicated in Fig. 6.
Replacing carbon brushes: <Disassembly>
(1)Loosen the D4 tapping screw retaining the brush cover and remove the brush cover.
Wear limit | No. of carbon | |||
brush | ||||
|
|
|
|
|
| 61 |
|
|
|
|
|
|
| |
|
|
|
| |
0.26" (6.5mm) 0.89" (22.5mm)
Fig. 6
Carbon | Spring | |
Brush | ||
Brush Holder | ||
| Fig. 7 |
15