English

ASSEMBLY AND OPERATION

APPLICATIONS

○Making wood carved handicrafts and precious metal ornaments

○Engraving and sculpting glass and ceramics

○Grinding and polishing steel and stone

BASIC FUNCTIONS

1.Low battery warning lamp (Fig. 3)

To check the remaining battery power, operate the grinder unloaded.

If the remaining battery power is low, the warning lamp (red LED) will light. If the lamp lights, charge the battery without delay.

Light

Switch dial

Low battery warning lamp

Fig. 3

NOTE

○The low battery warning lamp may be affected by the ambient temperature or battery characteristics. Use the lamp as a guide for when to charge the battery.

○The low battery warning lamp may light during operation of the grinder. This is due to a temporary drop in the battery voltage, and not to low battery power.

○When checking the remaining battery power, be sure to operate the grinder in an unloaded condition.

2.Switch dial

The switch dial also serves as the start-up switch and the speed dial. When the dial is rotated from [0] to a higher number, the grinder switches on and gradually builds up speed. At the same time, the LED lamp lights and illuminates the tip of the grinder.

When the dial is returned to [0], the grinder switches off and rotation stops.

For safety reasons, the grinder will not start up if the battery is inserted while the switch is at any position other than [0].

To switch the grinder on at such time, return the dial to [0] and then rotate it to a higher number. The approximate relationship between the numbers on the switch dial and the rotation speed is shown in the graph in Fig. 4.

Speed

Switch dial scale

Fig. 4

REMOVAL AND INSTALLATION METHOD OF BATTERY

○How to install the battery.

Align the battery with the groove in the housing and slip it into place.

Always insert it all the way until it locks in place with a little click. If not, it may accidentally fall out of the tool, causing injury to you or someone around you (Fig. 5).

○How to remove the battery.

Withdraw battery from the housing while pressing the latch (2 pcs) of the battery (Fig. 5).

Housing

Latch

Insert

Pull out

Battery Push

Fig. 5

14