English
○Regarding the temperature of the rechargeable battery.
The temperatures for rechargeable batteries are as shown in the table below, and batteries that have become hot should be cooled for a while before being recharged.
| Table 3 | |
Rechargeable |
| Temperatures at which the |
batteries |
| battery can be recharged |
BCL1015 |
| 32°F – 122°F (0°C – 50°C) |
○Regarding recharging time
Table 4 shows the recharging time required according to the type of battery.
Table 4 Recharging time (approx. min.) at 20°C
Battery | Battery capacity (Ah) | ||
voltage (V) |
| 1.5 Ah | |
10.8 | BCL1015 |
| 40 min. |
NOTE
The recharging time may vary according to the ambient temperature and the power supply voltage.
4.Disconnect battery charger from the receptacle.
CAUTION
Do not pull the plug out of the receptacle by pulling on the cord.
Make sure to grasp the plug when removing from receptacle to avoid damaging cord.
5.Remove the battery from the battery charger. Supporting the battery charger with hand, pull out the battery from the battery charger.
How to make the batteries perform longer
○Recharge the batteries before they become completely exhausted.
When you feel that the power of the tool becomes weaker, stop using the tool and recharge its battery. If you continue to use the tool and exhaust the electric current, the battery may be damaged and its life will become shorter.
○Avoid recharging at high temperatures.
A rechargeable battery will be hot immediately after use. If such a battery is recharged immediately after use, its internal chemical substance will deteriorate, and the battery life will be shortened. Leave the battery and recharge it after it has cooled for a while.
CAUTION
●When the battery charger has been continuously used, the battery charger will be heated, thus constituting the cause of the failures. Once the charging has been completed, give 15 minutes rest until the next charging.
●If the battery is charged while it is heated because it has been left for a long time in a location subject to direct sunlight or because the battery has just been used, the pilot lamp of the charger lights for 1 second, does not light for 0.5 seconds (off for 0.5 seconds). In such a case, first let the battery cool, then start charging.
●When the pilot lamp flickers (at
●If the battery charger does not work while the battery is mounted correctly, it is probable that the battery or charger is malfunctioning. Take it to your authorized Service Center.
BEFORE USE
Check the work area to make sure that it is clear of debris and clutter.
Clear the area of unnecessary personnel. Ensure that lighting and ventilation is adequate.
HOW TO ATTACH THE TIP TOOL
WARNING
To prevent accidents, be sure to switch the power off and remove the battery from the grinder.
CAUTION
Make sure the mandrel is screwed in tightly.
After attaching the tip tool, check that the tool is securely fixed.
If the tool is loose, it may come off, causing damage or injury.
1.How to use the
16