English

DEMOLITION HAMMER SAFETY WARNINGS

1.Wear ear protectors

Exposure to noise can cause hearing loss.

2.Use auxiliary handle(s), if supplied with the tool. Loss of control can cause personal injury.

3.Hold power tool by insulated gripping surfaces, when performing an operation where the cutting accessory may contact hidden wiring or its own cord. Cutting accessory contacting a "live" wire may make exposed metal parts of the power tool "live" and could give the operator an electric shock.

4.Do not touch the bit during or immediately after operation. The bit becomes very hot during operation and could cause serious burns.

5.Before starting to break, chip or drill into a wall, floor or ceiling, thoroughly confirm that such items as electric cables or conduits are not buried inside.

6.Even when the switch is on, the motor is running and the tool head is pressed to the demolition surface, the hammer sometimes does not start operating. In these instances, turn the switch off, press the tool head against the demolition surface again, and turn the switch on and off. This should start the demolition hammer operating. Repeat this procedure for several minutes, and the demolition hammer will heat, after which it will operate when switched to ON-LOCK.

SPECIFICATIONS

Voltage (by areas)*

(110V, 230V, 240V)

Power Input

930W*

Full-load Impact Rate

3000min–1

Weight (without cord, side handle)

5.1 kg

 

 

* Be sure to check the nameplate on product as it is subject to change by areas.

STANDARD ACCESSORIES

 

(1)

Case ...........................................................................

1

(2)

Bull Point (SDS-max shank) ..................................

1

(3)

Side Handle ..............................................................

1

Standard accessories are subject to change without

notice.

 

OPTIONAL ACCESSORIES (sold separately)

￿Crushing

(1)Bull Point

Overall Length: 280, 400 mm

￿ Asphalt Cutting

(1)Cutter

￿Surface Roughing

(1) Bushing Tool

(2) Shank

￿Tamping

(1) Rammer

(2) Shank

￿Groove digging and edging

(1) Cold chisel

Overall length: 280, 400 mm

￿Scooping Work

(1)Scoop

￿Hammer Grease A 500 g (in a can) 70 g (in a tube) 30 g (in a tube)

Optional accessories are subject to change without notice.

5