English
DEMOLITION HAMMER SAFETY WARNINGS
1.Wear ear protectors
Exposure to noise can cause hearing loss.
2.Use auxiliary handle(s), if supplied with the tool. Loss of control can cause personal injury.
3.Hold power tool by insulated gripping surfaces, when performing an operation where the cutting accessory may contact hidden wiring or its own cord. Cutting accessory contacting a "live" wire may make exposed metal parts of the power tool "live" and could give the operator an electric shock.
4.Do not touch the bit during or immediately after operation. The bit becomes very hot during operation and could cause serious burns.
5.Wear a mask when turning your head upward.
6.Properly set the bit holder
7.At the start of work, confirm screw tightening.
8.When working at a highly elevated location, pay attention to articles and persons below.
9.Wear protective shoes to protect your feet.
SPECIFICATIONS
Voltage (by areas)* | (110V, 115V, 120V, 127V, 220V, 230V, 240V) |
Power Input | 1340 W* |
1400 | |
Weight (without cord, side handle) | 16.5 kg |
* Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES |
| |
(1) | Case ............................................................................ | 1 |
(2) | Bull Point ................................................................... | 1 |
Standard accessories are subject to change without | ||
notice. |
| |
OPTIONAL ACCESSORIES (sold separately)
Asphalt Cutting
Scooping Work
(1) Scoop
Overall Length: 410 mm
Grease
500 g (in a can)
30 g (in a tube)
Optional accessories are subject to change without notice.
(1)Cutter
Overall Length: 410 mm Width: 75 mm
Groove Digging and Edging
(1)Cold Chisel
Overall Length: 410 mm
Tamping
(2)Shank
Overall Length: 250 mm
(1)Rammer
Outer diameter: 200 mm
APPLICATIONS
Demolishing concrete, chiseling off concrete, grooving, bar cutting.
Application examples:
Installation of piping and wiring, sanitary facility installation, machinery installation, water supply and drainage work, interior jobs, harbor facilities and other civil engineering works.
PRIOR TO OPERATION
1.Power source
Ensure that the power source to be utilized conforms to the power requirements specified on the product nameplate.
2.Power switch
Ensure that the power switch is in the OFF position. If the plug is connected to a receptacle while the power switch is in the ON position, the power tool will start operating immediately, which could cause a serious accident.
3.Extension cord
When the work area is removed from the power source, use an extension cord of sufficient thickness and rated capacity. The extension cord should be kept as short as practicable.
5