How To Order Spare Parts, Warranty, Date Purchased

17. For normal operation both plates should be fully opened. To reduce flow to the left side, partially or completely close the plate over the rear (large) hole. To reduce flow to the right side, partially or completely close the plate over the front (small) hole. Close both plates for a narrow center spread pat- tern. WARNING: If the optional side de- flector is being used in the down position, the plate over the rear (large) hole MUST BE CLOSED or an over application of material will occur.

16.Tension on the flow control lever may be adjusted by tightening or loosening the tension nut as shown.

The settings furnished on the Rate Setting Chart are intended as a guide only. Variations in physical characteristics of material applied, walking speed, and roughness of ground surface may require slightly different spreader settings. Due to the above conditions, EARTH- WAY PRODUCTS, INC. makes no warranty as to the uniformity of coverage actually obtained from the settings listed.

WARRANTY

EARTHWAY guarantees this product to be free of defects in origi- nal workmanship and materials for a period of 90-days from sale to the original user. If any defect develops during this period EARTHWAY will repair or replace this product at no charge pro- vided the defect is not the result of mishandling or tampering and that this product is received at the factory with shipping charges prepaid. For quicker service you may call EARTHWAY at 574- 848-7491 or write and describe the nature of the defect and we will send repair parts to you. Due to the corrosive nature of most fertil- izers and ice melters, EARTHWAY PRODUCTS, INC. makes no warranty or guarantee against corrosion failure on models with plated steel or painted steel frames. Clean your spreader well after each use. Warranty covers parts only, but not labor charges.

DO NOT RETURN TO DEALER FOR REPAIR

OPERATING INSTRUCTIONS

Before filling hopper, become familiar with the operation of this spreader.

Obtain proper setting for material to be used from the RATE SETTING CHART included with this spreader. Move stop bolt on rate gauge assembly to the proper setting.

While pushing spreader forward, pull control lever back to stop bolt.

To stop, push lever forward to close flow holes before you stop moving.

When finished, empty any remaining material from hop- per.

Thoroughly wash spreader and allow to dry before stor- ing. No oiling is necessary.

EARTHWAY PRODUCTS, INC.

1009 Maple Street

P.O. Box 547

Bristol, IN 46507

FOR YOUR RECORDS

_________________________________________

Date Purchased

_________________________________________

Store Name