3.Install impeller onto pinion shaft. Insert 1/8” x 1 ” cotter pin through impeller then through pinion shaft. Use hole nearest gear box. Spread cotter pin to prevent from falling out.
5.A - Install lower handles onto axle to both sides as shown. Now insert 1 1/2” bolt through first hole in lower handle. Then through frame brace. NOTE: Dimples on frame brace must be facing toward gear box as shown. Next into threaded connector in cross brace. DO NOT TIGHTEN YET. B - Next insert 1 1/2” bolt through other end of frame brace and through second hole in frame install locknut. DO NOT TIGHTEN YET. C - Now in- sert 2 1/4” bolt through second hole in lower handle and through first hole in frame.
4.Install gear box by inserting the pinion shaft into hole in center of hoppers bottom. The word “FRONT” on the gearbox must point to Front of the hopper.
NOW GO BACK AND TIGHTEN ALL NUTS AND BOLTS STARTING WITH FIRST STEP. DO NOT OVER TIGHTEN. PAGE 2
