English

ACCESSORIES

DANGER

￿Accessories other than those shown below can lead to malfunction and resulting injuries.

STANDARD ACCESSORIES

 

1

Safety glasses ...............................

1

 

2

Battery ...........................................

1

 

3

Charger .........................................

1

1

4

Case ...............................................

1

5

Allen wrench for M5 screw

1

 

(attached to body)

2 3

4 5

OPTIONAL ACCESSORIES

sold separately

 

￿ Fuel Cell

Code No. 728-980

￿Gas Strip Nailer Lubricant

8 oz. (250 cc) oil feeder (Code No. 885-546)

NOTE: Accessories are subject to change without any obligation on the part of HITACHI.

APPLICATIONS

￿Floor and wall framing.

￿Truss build-up, Window build-up.

￿Subflooring and roof decking.

￿Wall sheathing.

￿Mobile home and modular housing construction.

REMOVAL AND INSTALLATION METHOD OF BATTERY

￿How to install the battery

Align the battery with the groove in tool handle and slip it into place.

Always insert it all the way until it locks in place with a little click. If not, it may accidentally fall out of the tool, causing injury to you or someone around you.

￿How to remove the battery

Withdraw battery from the tool handle while pressing the latch on the side of the battery.

Handle

Latch

Insert

Pull out

Battery

CHARGING METHOD

NOTE: Before plugging into the receptacle, make sure the following points.

￿The power source voltage is stated on the nameplate.

￿The cord is not damaged.

WARNING

￿Do not charge at voltage higher than indicated on the name plate.

If charged at voltage higher than indicated on the nameplate, the charger will burn up.

￿Do not use the electrical cord if damaged. Have it repaired immediately.

1.Insert the battery into the battery charger. Make sure it contacts the bottom of the battery charger.

2.Insert the plug of battery charger into the receptacle.

3.Charging

￿When the plug of battery charger has been inserted into the receptacle, charging will commence and the pilot lamp will light on.

NOTE: If the pilot lamp does not light, pull out the plug from the receptacle and check if the battery is properly mounted.

￿In approx. 60 min. at 70°F (20°C), when the battery is fully charged, the pilot lamp will go out.

NOTE: The battery charging time becomes longer when a temperature is low or the voltage of the power source is too low.

When the pilot lamp does not go off even if more than four hour has passed after start of the charging, stop the charging and contact your

HITACHI AUTHORIZED SERVICE CENTER.

— 12 —