Adjust the air pressure at recommended operating pressure 70 – 120 psi (4.9 – 8.3 bar 5 – 8.5 kgf/cm2) according to the length of nails and the hardness of workpiece.

The correct air pressure is the lowest pressure which will do the job. Using the Nailer at a higher than required air pressure unnecessarily over stresses the Nailer.

LOADING NAILS

WARNING

When loading nails into Nailer,

1)do not pull trigger;

2)do not depress push lever; and

3)keep Nailer pointed downward.

(1)Grip the nail guide and knob with finger.

Press the knob down and swing the nail guide open. And open the magazine cover.

Knob

English

1Turn the nail holder about 90 degrees counterclockwise.

Slide in vertical direction possible.

Lift or lower the nail holder to accept dierent length nails.

Adjust the plate to the nail length reference points on the magazine cover and turn the nail holder 90

degrees clockwise until you hear "click".23

2"

 

21/4" 23/8"

2

21/2" 23/4"

 

3" 31/4"

1

Magazine

3

Nail holder

(3)Place the nail coil into the magazine.

Uncoil enough nails to reach the driving hole.

Nail guide

Magazine cover

 

Magazine

Nails

Nail holder

(2) Adjust the position of the plate according to the nail

 

 

(4) 1 Uncoil enough nails to reach the driving hole.

length.

 

The nail will not feed smoothly if the plate is not

2 Insert the first nail into the driving hole and the

correctly adjusted.

 

second nail between the two pawls of the feeder.

 

 

3 Fit the nail heads in the guide slot.

 

 

First nail

Driving hole Guide slot

 

 

2

3

 

 

 

Nail Guide

 

 

 

 

 

4

 

 

 

 

 

 

 

 

 

 

1

Magazine

Magazine cover

 

 

 

 

Nail holder

 

 

 

 

NOTE: Before loading nails in the magazine, adjust

 

 

Guide surface

the plate. If the magazine cover is forcibly

 

2

 

Feeder

closed without adjusting the plate correctly,

 

 

the nail holder may be damaged.

4 Pulling the nails to the right, swing the nail guide

 

 

closed.

 

13