NAMES AND FUNCTIONS OF EACH PART
REMOTE CONTROLLER
This controls the operation of the indoor unit. The range of control is about 7 meters. If indoor lighting is controlled electronically, the range of control may be shorter.
This unit can be fixed on a wall using the fixture provided. Before fixing it, make sure the indoor unit can be controlled from the remote controller.
● Signal emitting window/transmission sign
Point this window toward the indoor unit when controlling it.
The transmission sign blinks when a signal is sent.
● Display
This indicates the room temperature selected, current time, timer status, function and intensity of circulation selected.
● START/STOP button
Press this button to start operation. Press it again to stop operation.
● FAN SPEED selector
This determines the fan speed. Every time you press this button, the intensity of circulation will change from 
(AUTO) to 
(HI) to 
(MED) to 
(LOW) (during the 
(FAN) mode, from 
HI to 
MED to 
LOW).
●AUTO SWING button
Controls the angle of the horizontal air deflector.
●TEMPERATURE buttons
Use these buttons to raise or lower the temperature setting. (Keep pressed, and the value will change more quickly.)
● SLEEP button
Use this button to set the sleep timer.
● TIME button
Use this button to set and check the time and date.
●RESET buttons
● FUNCTION selector
Use this button to select the operating mode. Every time you press it, the mode will change from 
(AUTO) to 
(HEAT) to 
(DEHUMIDIFY) to 
(COOL) and to 
(FAN) cyclically.
● PARALLEL SWING button
Controls the angle of the vertical air deflectors to parallel.
●SYMMETRY SWING button
Controls the angle of the vertical air deflectors to symmetry.
●TIMER control
Use this button to set the timer.
●
●
●RESERVE button Time setting reservation.
●CANCEL button Cancel time reservation.
Precautions for Use
● Do not put the remote controller in the following places. ● In direct sunlight.
● In the vicinity of a heater.
● Handle the remote controller carefully. Do not drop it on the floor, and protect it from water.
● Once the outdoor unit stops, it will not restart for about 3 minutes (unless you turn the power switch off and on or unplug the power cord and plug it in again).
This is to protect the device and does not indicate a failure.
● If you press the FUNCTION selector button during operation, the device may stop for about 3 minutes for protection.
– 6 –
