Lining paper
Slit part
Fig. 1
(2)After ensuring that the sanding pad is free of dust and oil, mount the sanding paper to the sanding pad as shown in Fig. 2, ensuring that the outer circumferences of the pad and paper are matched.
Sanding paper
Sanding pad
Fig. 2
(3)Ensure that the sanding paper is securely attached to the pad by pressing the paper strongly with the palm of the hand, as shown in Fig. 3.
Press strongly
PRACTICAL OPERATING PROCEDURES
1.Turn the sander on after lightly applying it to the surface to be sanded. Never leave the rotating tool unattended.
2.Do not apply excessive pressure to the sander. Excessive pressure may result in deterioration of the sanded surface, and overloading of the tool.
3.Hold the housing and side handle of the sander securely during operation.
4.The sanding paper should be removed as soon as possible after completion of the operation. Sanding paper left on the pad for several days may be very difficult to remove.
5.After removing the sanding paper, ensure that any adhesive remaining on the sanding pad is removed completely by wiping it. Should any adhesive remain, dust and dirt will adhere to the pad, resulting in reduced adhesion when another sanding paper is mounted.
6.Do not attempt to reattach sanding paper to the pad once it has been removed. Reduced adhesive strength could cause the sanding paper to come
flying off the pad, creating a serious hazard.
CAUTION
Immediately after use, DO NOT Iay the tool down or touch the sanding pad until the rotation parts of the tool come to a complete stop. Laying the tool down in this manner could cause grit and dirt to be sucked into the tool. Touching the rotating sanding paper could cause serious injury.
REPLACING A SANDING PAD
1.Insert the accessory bar wrench into the groove of the spindle connector and the opening of the pad spindle, as shown in Fig. 4.
Pad spindle | Opening |
| |
| Groove |
Spindle connector | Bar wrench |
| |
| Fig. 4 |
Fig. 3
CAUTION
If the sanding paper is not attached securely as described above, it could come off during operation, inviting serious injury. As the adhesive may deteriorate if the sanding paper is removed and reattached several times, the sanding paper should be aligned and attached securely in a single operation.
2.Holding the bar wrench, the sanding pad is tightened by rotating in to the right (clockwise), and loosened by rotating it to the left (counterclockwise), as shown in Fig. 5.
5