SYNCHRO EDIT
SYNCHRO EDIT
Synchro edit allows your camera/recorder to control a compatible VCR (one that has a camera pause jack) while tapes are being copied from the camera/recorder to the VCR. This is convenient when you want to record only selected segments from a previously recorded tape.
Synchro edit hookup Illustration
1.Connect your camera/recorder to a compatible VCR as shown above. An optional synchro edit cord is required
NOTE: If your VCR has a single (mono) audio input, connect either the left or right audio plug to audio input on the VCR.
2.Insert the recorded tape into the camera/recorder.
3.Insert the blank tape into the recording VCR.
4.Press "PLAY" button on the camera/recorder and the press "PAUSE" button where you want to copy.
5.Press "RECORD" button on the VCR. The VCR automatically enters record/pause mode.
NOTE: If the VCR begins to record instead of pausing, you will need to change the position of the switch on the synchro edit cord. Stop the VCR, change the switch, and then press "RECORD" button on the VCR again.
6.Pressing "REVIEW" button on the camera/recorder puts the camera/recorder in the preview mode for several seconds and then into the playback mode. The recording VCR starts recording automatically.
7.Pressing "REW", "F.FWD", "STOP" or "PAUSE" on the camera/recorder automatically put the VCR into the record/pause mode. This allows you to search (forward or backward),
• To search forward (or backward), press "F.FWD" or "REW" button. When you press "PLAY" button, the camera/recorder will resume normal playback. To begin copying again, press "PAUSE" button and then the "REVIEW" button.
• To
73