30

29

Fig. 34

Angle transmission (Fig. 35)

Check angle transmission or angle gear for grease level about every 50 hours of operation by removing the grease filler plug on the side of angle transmission.

If no grease can be seen on the flanks of the gears, fill the transmission with quality lithium based multipurpose grease up to 3/4. Do not completely fill the transmission.

Fig. 35

Semi-auto cutting head

Nylon line replacement

(1) Remove the case (31) by firmly pushing inward the locking tabs with your thumbs as shown in Fig. 36.

31

Fig. 36

(2)After removing the case, take out the reel and discard the remaining line.

(3)Fold the new nylon line unevenly in half as shown in picture. Hook the U-shaped end of the nylon line into the groove (32) on the center partition of the reel.

Wind both halves of the line on the reel in the same direction, keeping each half of the line on its own side of the partition. (Fig. 37)

10 cm

32

Fig. 37

(4)Push each line into the stopper holes (33), leaving the loose ends approx. 10 cm in length. (Fig. 38)

10 cm

cm

33

10

 

Fig. 38

(5)Insert both loose ends of the line through the cord guide (34) when placing the reel in the case. (Fig. 39)

33

34

Fig. 39

NOTE

When placing a reel in the case, try to line up the stopper holes (33) with the cord guide (34) for easier line release later.

(6) Place the cover over the case so that the cap locking tabs (35) on the case meet the long holes (36) on the cover. Then push the case securely until it clicks into place. (Fig. 40)

36

35

Fig. 40

(7)The initial cutting line length should be approx. 11–14 cm and should be equal on both sides. (Fig. 41)

12