NOTE

When it is hard to insert drive shaft up to the marked position on the drive shaft tube, turn drive shaft by the cutter mounting end clockwise or counter-clockwise. Tighten tube locking bolt lining up the hole in the shaft tube. Then tighten clamp bolt securely.

Installation of attachment

1. Join the attachment in place of it.

2. Make sure the lock pin (3) fits in the location hole (4) of tube and that the tube will not come o. (Fig. 2)

3. Tighten the knob nut (5) securely. (Fig. 2)

3

5

4

Fig. 2

Installation of handle

WARNING

When you use steel/rigid blades on straight shaft trimmers or brush cutters, always use a barrier bar (6) and shoulder harness with the loop handle. (Fig. 3)

6

Fig. 3

Attach the handle to the drive shaft tube with the angle towards the engine.

Adjust the location to the most comfortable position before operation.

NOTE

If your unit has handle location label on drive shaft tube, follow the illustration.

Remove the handle bracket (7) from the assembly. (Fig. 4)

Place the handles and attach the handle bracket with four bolts lightly. Adjust to appropriate position. Then attach it firmly with the bolts.

7

Fig. 4

6

Attach the protection tube to the drive shaft or handle using cord clamps (8). (Fig. 5)

8

Fig. 5

Throttle wire / stop cord

Press the upper tab (9) and open the air cleaner cover. (Fig. 6)

9

Fig. 6

Connect stop cords. (Fig. 7)

Fig. 7

If the throttle outer end (10) is threaded on your unit, screw it and the earth terminal (11) (if so equipped) into the cable adjuster stay (12) all the way, and then tighten this cable end using the adjuster nut (13) against the cable adjuster stay (12).

Connect throttle wire end (14) to carburetor (15) and install swivel cap (16) (if so equipped) where is included in tool bag, onto swivel (15) (Fig. 8).

Some models may come with the parts installed.

12

16

11

15

 

10

14

13

Fig. 8