Hitachi Koki USA W6VM Mounting and Dismounting the HEX-SOCKET or the BIT, Dismounting the bit Fig

English

4.Tightening Self-drilling screw

When the supplied magnet bit holder is used to tighten the Self-drilling screw into a steel plate, cut material stuck in the magnet bit will degrade the work efficiency.

To prevent this, the non-magnetic bit holder (optional accessory) is recom- mended. The stainless locator with bushing (optional accessory) will prevent the bushing from being worn.

MOUNTING AND DISMOUNTING THE HEX-SOCKET OR THE BIT

CAUTION

Be sure to switch power OFF and disconnect the plug from receptacle to avoid serious trouble.

1.Dismounting the hex-socket (Fig. 7)

(1) While rotating the Sub-Stopper pull it out from the locator.

(2) Remove the hex-socket, hold it with the opposite side of bit by hand or vise and pull out the bit with pliers.

2.Dismounting the bit (Fig. 8)

Remove sub-stopper (G) as the same manner of hex-head socket and remove the bit holder, then pull out the bit with pliers.

3.Dismounting the bit (Fig. 9)

Remove the sub-stopper (F) as the same manner of hex-head socket and remove the bit holder, then pull out the bit with pliers.

4.Mounting the hex-socket or the bit

Install the bit in the reverse order to removal.

Sub-Stopper (B)

Magnetic hex. socket

Fig. 7

Sub-Stopper (G)

Bit Bit holder (Short type)

Fig. 8

Sub-Stopper (F)

Bit Bit holder

Fig. 9

13