3.Loosen the two retaining nuts, and remove the mixing arm pilot bushing assembly. Rotate and remove the bushing retainer. Disengage and pull mixing arm from the square drive and lift the arm from the hopper.
4.Wash machine with hot water or steam. When using detergents and sanitizers, follow manufacturer's instructions. Rinse with clear water. Allow to
5.When
6.Assemble mixing arm, cylinder, end ring, knife, plate and conveyor screw into
7.Reconnect electrical power supply.
HEATER
The
LUBRICATION
Both motor bearings are prelubricated and sealed. No further lubrication is required.
SERVICE
Contact your local Hobart Service Office for any repairs or adjustments needed.
TROUBLESHOOTING
Problem | Possible Cause | |
|
| |
Machine will not run. | 1. Hopper lid not closed completely. | |
| 2. | Plug disconnected from receptacle. |
| 3. | Circuit breaker tripped. |
|
| |
Poor grind result. | 1. Adjusting ring loose. | |
| 2. | Knife or plate dull. |
| 3. | Knife and plate not seated properly. |
| 4. | Plate stud broken. |
| 5. | Knife broken. |
|
|
|
SERVICE
Contact your local Hobart Service Office for any repairs or adjustments needed on this equipment.
FORM 34821 (Aug. 2002) | – 8 – | PRINTED IN U.S.A. |