Hobart 873440 manual Assembly Instructions, Adapter - KIT NO, Adapter Kit complete

ASSEMBLY INSTRUCTIONS

Adapter — KIT NO. 873440

For Hobart PRIME™ Mixer-Grinders with 15° incline cylinder and Hollymatic model 120 Bulker.

PART NO.	NAME OF PART	AMT.
873440	Adapter Kit (complete)	.......................................................... 1
873430	Adapter, Bulker	1
873437	Long Support Rod	1
F-34483	Assembly Instructions	1

ASSEMBLY

WARNING: DISCONNECT ELECTRICAL POWER.

1.Remove the paper roll from the Hollymatic Model 120. Pull the pin out of the bracket underneath the bulker. Remove the Bulker from its pedestal by lifting straight up. Carefully set the Hollymatic Model 120 Bulker on its side (Fig. 1).

PAPER ROLL

HOLLY BULKER

BRACKET

PIN

PL-41437-1

Fig. 1

2.Unscrew the height adjustment screw and remove the support rod from the pedestal. The long rod from the kit must be used with the Hobart PRIME™ Mixer-Grinder.

3.Assemble the Long Support Rod from the kit into the pedestal base making sure the grooved part of the Support Rod is up. Re-tighten the height adjustment screw so the support rod is stable, Fig. 2.

701 S. RIDGE AVENUE

TROY, OHIO 45374-0001

937 332-3000

LONG SUPPORT ROD

HEIGHT ADJUSTMENT SCREW

PEDESTAL

BASE

PL-41438-1

Fig. 2

www.hobartcorp.com FORM 34483 (May 2000)