Hobart HCM62 manual Bowl and Knife Assembly

BOWL AND KNIFE ASSEMBLY

Install the Bowl so the center post of the Bowl fits over the motor shaft, one of the Bowl Pins fits in the slot at the front of the machine, and the bowl handles are positioned on left and right (Fig. 1). Install Knife Shaft over center bowl post so the slots on the Knife Shaft fit the grooves on the motor shaft (Fig. 1).

The four Bowl Scraper Wipers must be properly installed in the grooves of the Bowl Scraper. The upper tips of the wipers point straight up and slightly toward the center (Fig. 2); the ends of the wipers are vertical so they do not interfere with the lip of the Bowl Cover. Do not install the wipers backwards.

After installing the Lid Plug, turn it so the underneath side of the plug is flat with the underneath side of the Bowl Cover (Fig. 3). The Bowl Cover Gasket must be properly installed in the groove around the lip of the Bowl Cover (Fig. 3).

ARM

MOTOR SHAFT

KNIFE SHAFT

BOWL

HANDLE

BOWL

BOWL PIN

SLOT
	PL-41421-1

Fig. 1

TIPWIPER

END

BOWL SCRAPER

PL-41422-1

		Fig. 2
			BOWL COVER GASKET
	BOWL COVER
LIP
				ALIGMENT PIN

LID PLUG

PL-41423-1

Fig. 3

– 4 –