Fit the Bowl Cover over the Bowl Scraper so the center holes align. Fit the Scraper Handle Shaft through the center hole in the Bowl Cover into the Slots of the Bowl Scraper. The Bowl Cover Tab must fit around the 180° Cam on the Scraper Handle. The Tabs on the Scraper Handle Shaft must fit through the Slots in the center hole of the Bowl Scraper.
Place the assembled Bowl Cover / Bowl Scraper/ Scraper Handle on a flat surface. Press down on the Scraper Handle (Fig. 5) and turn it clockwise 1/8 turn so the Tabs engage with the bottom of the Slots. The Bowl Cover / Bowl Scraper / Scraper Handle are now joined as one piece.
Move the Scraper Handle until it is positioned over the Lid Plug.
Place the assembled Bowl Cover / Bowl Scraper/ Scraper Handle in the Bowl. The Bowl Scraper Legs touch the sides of the Bowl. The Bowl Cover Handles set directly above the Bowl Handles (Fig. 6). The Alignment Pins under the Bowl Cover Handles fit the holes in the Bowl Handles (Fig. 6).
SHAFT
180° CAM
BOWL TAB COVER
TAB
Fig. 4
PRESS HANDLE DOWN THEN TURN CLOCKWISE
1/8 TURN TO ENGAGE
Fig. 5
ARM 
BOWL COVER
Fig. 6
SCRAPER HANDLE
BOWL
COVER
HANDLE
SCRAPER
HANDLE
BOWL
COVER
HANDLE
ALIGNMEMT
PIN
BOWL HANDLE
BOWL
Swing the Arm forward so the end of the Arm fits over the center of the Bowl above the Scraper Handle (Fig. 7). The Arm must be properly positioned over the center of the Bowl and all parts must be properly assembled before the machine will operate.
ARM | BOWL SCRAPER HANDLE |
|
Fig. 7
– 5 –
