Hobart ML-104650, ML-104651, ML-104654 manual Legs Or Casters, Leveling, Check Gear Case Lubricant

LEGS OR CASTERS

With the mixer-grinder securely elevated using the base frame for support, bolt the leg or caster assemblies through the corner holes using 5/8" bolts and lockwashers, provided.

LEVELING

Adjust the feet (or caster legs) so the mixer-grinder is level, both front-to-back and side-to-side.

CHECK GEAR CASE LUBRICANT

Oil is installed in the gear case at the factory. Make sure oil is at the proper level by checking the oil level sight gauge (Fig. 1). If it is necessary to add oil, unscrew the retaining screws and remove the rear panel (Fig. 1). Remove the oil fill plug (Fig. 1) and add Mobil DTE HM oil until the oil level is brought to the center of the oil level sight gauge.

CHECK CHAIN LUBRICANT RESERVOIR

Oil is added to the chain reservoir at the factory and sealed at the bottom of the splash shield with a silicone rubber sealant for shipping purposes. With the rear panel removed, remove the sealant from around the chain reservoir (Fig. 1) and inspect the oil level. Replenish as necessary with MPO-30 Multi-Purpose Oil.

HOPPER GUARD

MIX SWITCH

MIX-GRIND SWITCH

STOP SWITCH

FOOT SWITCH ON-OFF

LEVELING FOOT

PL-52463

HOPPER GUARD INTERLOCK

REAR PANEL

SEALANT ON CHAIN RESERVOIR

OIL FILL PLUG

OIL LEVEL SIGHT GAUGE

DRAIN PLUG

ELECTRICAL SUPPLY JUNCTION COMPARTMENT

Fig. 1

– 3 –