Hobart ML-134334

– 24 –

Transmission

To check the oil level, remove the top cover, which is secured by two screws. Remove the Transmission Fill

Plug (Fig. 12) and check the oil level. If the oil level is below the line on the oil dipstick, add a small amount

of the recommended transmission oil until it returns to the proper level. Do not overﬁ ll the transmission, as

leakage may result. Contact your local Hobart Service Ofﬁ ce for the recommended transmission oil.

Fig. 12

ADJUSTMENTS

Agitator Clearance

The agitator clearance should be checked periodically. The agitator must not touch the bowl, and the

maximum clearance between the bottom of the bowl and the B ﬂ at beater is 1/8" (3 mm); the maximum

clearance between the bottom of the bowl and the ED dough arm is 5/16" (8 mm) for the HL800 Mixer and

11/16" (17 mm) for the HL1400 Mixer.

Install a bowl and agitator (e.g., beater). If the bowl and beater come into contact before the bowl support

reaches its stop, adjust the stop screw. Refer to Adjust the Bowl/Agitator Clearance, page 25.