– 7 –
MIXING
This section explains operation of the mixer and how to install bowls and agitators.
BOWL
New mixer bowls and agitators (beaters, whips, dough
arms and splash cover) should be thoroughly washed
with hot water and a mild soap solution, rinsed with
either a mild soda or vinegar solution, and thoroughly
rinsed with clear water before being put into service.
This cleaning procedure should also be followed for
bowls and agitators before whipping egg whites or
whole eggs.
The bowl must be installed before the agitator. To
install the bowl, fully lower the bowl support (Fig. 3).
Position the bowl so two large holes on bowl tabs
are above the bowl pins on the bowl support. Lower
the bowl onto the bowl pins then turn clockwise until
stopped in locked position.
AGITATOR
To install an agitator (Fig. 4), the bowl must be installed and fully lowered. Place the agitator in the
bowl, push it up on the agitator shaft, and turn it clockwise to seat the shaft pin in the slot of the agitator
shank.
Fig. 4Fig. 4