Hobart Welding Products H-9B Gun manual Threading Welding Wire, Input Power

3-5. Threading Welding Wire

1 Wire Spool

2 Welding Wire

3 Inlet Wire Guide

4 Pressure Adjustment Knob

5 Drive Roll

6 Gun Cable

Lay gun cable out straight.

4

Tools Needed:

			6
1	2	3	5

Open pressure assembly.

Tighten

.Hold wire tightly to keep it from unraveling.

6 in (150 mm)

Pull and hold wire; cut off end.

.Loosen knob completely, then rotate

pressure adjustment knob in a clockwise direction until drive roll is tight against the welding wire.

Adjust drive roll pressure just tightly enough to prevent wire from slipping against drive roll during operation.

4 in (102 mm)

Push wire thru guides into gun liner;

continue to hold wire.

INPUT

POWER

Be sure that wire is positioned

in proper feed roll groove. Close and tighten pressure assembly, and let go of wire.

Press gun trigger until wire comes out of gun.

Remove gun nozzle and contact tip. Turn power on.

.Tip adapter may also require removal to allow wire to feed out end of gun.

Tighten

	WOOD
Be sure that contact tip matches wire diameter.	Feed wire to check drive roll pressure.
Reinstall tip adapter, if applicable, contact tip	Tighten knob enough to prevent slipping.
and nozzle.	Cut off wire. Close door.
	Ref. 803 444-A / Ref. 205 837

OM-225 333 Page 6