When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:
• Read all instructions before using the appliance. |
• To avoid fire or shock hazard, plug the appliance |
directly into a 120V AC electrical outlet. |
• If the filter is covered by a bag when shipped: Remove |
plastic bag before use. |
• Keep the cord out of heavy traffic areas. To avoid fire |
hazard, NEVER put the cord under rugs, near heat |
registers, radiators, stoves, or heaters. |
• To protect against electrical hazards, DO NOT immerse |
in water or other liquids. Do not use near water. |
• Close supervision is necessary when any appliance is |
used by or near children, or disabled persons. |
• Always unplug the air purifier before moving it, opening |
the grill, changing the filters, cleaning, or whenever the |
air purifier is not in use. Be sure to pull by the plug and |
not the cord. |
• NEVER drop or insert any object into any openings. |
• DO NOT operate any appliance with a damaged cord or |
plug, if motor fan fails to rotate, after the appliance |
malfunctions, or if it has been dropped or damaged in any |
manner. Return appliance to manufacturer for examination, |
electrical or mechanical adjustment, or repair. |
• Use appliance only for intended household use as described |
in this manual. Any other use not recommended by the |
•DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit. Doing so will void your warranty. The inside of the unit contains no user serviceable parts. All servicing should be performed by qualified personnel only.
•WARNING: To reduce the risk of fire or electric shock, DO NOT use this air purifier with any solid-state speed control device.
•DO NOT place anything on top of unit.
PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS
CORD AND PLUG INSTALLATION SAFETY INSTRUCTIONS
The length of cord used on this appliance was selected to reduce the hazards of becoming tangled in, or tripping over a longer cord. If a longer cord is necessary, an approved extension cord may be used. The electrical rating of the extension cord must be equal to or greater than the rating of the air purifier. Care must be taken to arrange the extension cord so that it will not drape over the countertop or tabletop where it can be pulled on by children or accidentally tripped over.
Thank you for choosing a Holmes® air purifier. To ensure the best performance from your air purifier, please read and save the following instructions.
IONIZER
Your air purifier has an independently controlled ionizer, which, when turned on, releases negative ions into outgoing filtered air. Ions are tiny particles that carry a positive or negative charge. These ions exist naturally around us, in the air, water, and ground. Both positive and negative ions are colorless, odorless, and completely harmless. Negative ions help the air purification process by attaching themselves to very small airborne particles in the room.
These particles take on a negative charge and may join with positively charged particles such as dust, pollen, smoke, and pet dander to form larger particles that are then more readily captured by the filter system, or may be attracted to positively charged surfaces throughout the home, like walls or floors. This may occur more frequently when the filter is nearing the end of its functional life expectancy and is able to capture less of the charged particles.
You may also note after extended use, that dust has collected around the grills or front panel. This is from the ionization affect caused by the negative ions exiting from the air outlet. This is additional evidence of the air cleaning effectiveness of negative ions. The dust can be easily
Finally, using your ionizer may result in an occasional popping or cracking sound. This is a normal sound, generally caused by a small build-up of ions that, when discharged, cause the popping or cracking sound.
NOTE: It is important to replace the HEPA-type filters at the recommended intervals.
Using the ionizer in conjunction with dirty filters may result in dirty particles exiting the air purifier and being attracted to walls, carpets, furniture, or other household objects. These dirty particles may prove very difficult to remove. Homes with excessive amounts of pet dander, dust, or smoke may decrease the life expectancy of the HEPA-type filtration system and may interfere with the ionization process. You may want to run the Ionizer less often and check the condition of the HEPA-type filter(s) more frequently in order to reduce particles from being attracted to surfaces throughout your home as mentioned above.
PRE-OPERATING INSTRUCTIONS
1. | Carefully unpack your air purifier. Select a firm level |
| place where there are no obstructions to the air inlet or |
| filtered air outlet. A good location in a room is |
| approximately 1 foot away from the wall, in a central |
| location of your home. |
2. | Pull air inlet grill towards you by grasping the finger |
| tabs and pulling forward . |
E | | | |
| F | G | H |
A. Ionizer Knob | E. Filtered Air Outlet |
4.This model utilizes a hang tab and filter clip. The clip can only be
attached to the tabs on | |
the filter one way only. | |
The | filter | clip | should | |
easily slide onto the filter | Fig. 2 |
hang | tab | with | only a |
small amount of pressure. | |
DO NOT use force while | |
attaching the clip to the | |
filter (See Fig. 2). Align | |
the clip on the top of the | |
HEPA-type filter with the | |
rails on the inside of the | |
air purifier | unit. Gently | |
slide | the filter onto the | Fig. 3 |
rail (See Fig. 3).
NOTE: The pleated material and rubber gasket should be facing towards the unit when applied.
5. | If the filters are enclosed in plastic bags please |
| ensure that the bags are removed prior to |
| operation. |
6. | Replace air inlet grill back onto unit securely. |
7. | The filter reminder dial should be set ahead 3 months, |
| to indicate when the filter conditions should be checked |
| and replaced. (See FILTER REPLACEMENT INSTRUCTIONS |
OPERATING INSTRUCTIONS
1.Plug into a 120V AC electrical outlet.
2.Select the desired operating speed; HI (
), MEDIUM (
),
LOW ( ), by turning Speed Control Knob to the appropriate setting.
3.To release negative ions into the filtered air, turn the Ionizer Knob to ON (
) and the light will illuminate.
4.The ionizer will not work unless the unit is running.
5.For optimum air filtration, it is recommended to operate the air purifier continuously. Its rugged motor has been designed to give many years of use.
CLEANING/MAINTENANCE INSTRUCTIONS
1.Turn the air purifier off and unplug it before cleaning.
2.The outside of the air purifier can be cleaned with a soft, clean dampened cloth.
3.The rear air inlet grill can be removed and washed in warm soapy water (not dishwasher safe). Dry before replacing in the unit.
4.The filtered air outlet can be cleaned of dust with a small, soft brush.
5.If you wish to clean the inside of the air purifier, please only use a dry, soft cloth to wipe it down.
WARNING: Do not allow moisture to come in contact with the main housing of the air purifier.
FILTER REPLACEMENT INSTRUCTIONS
1.Every few weeks, check the condition of the pre-filter.
2.Remove the rear grill. Examine the foam pre-filter. If the pre-filter has collected a noticeable amount of dust or lint, remove it from the inlet of the grill and wash it in warm soapy water. Rinse and drip dry the pre-filter thoroughly before replacing it in the inlet of the grill.
3.With the rear grill removed, remove the used HEPA-type cartridge and dispose of it in the garbage. DO NOT try to wash and re-use the HEPA-type filter. Replace with a new HEPA-type HAPF30 filter, removing the protective polybag before inserting into the air purifier.
4.Align the clips on the top of your HEPA-type filter with the rails on the inside of the unit. Gently slide the filter onto the rail.
NOTE: The pleated material and rubber gasket should be facing towards the unit when installed.
5.Filter Life – Under normal conditions of continuous use, the HEPA-type filter will operate efficiently for 3-6 months.
6.Replacement filters (HAPF30) are available from your local supplier or by calling 1-800-253-2764.
7.The filter reminder dial should be set ahead 3-6 months depending on usage.
THIS PRODUCT IS EQUIPPED WITH A POLARIZED PLUG (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact qualified personnel to install the proper outlet.
DO NOT DEFEAT THE SAFETY PURPOSE OF THIS
POLARIZED PLUG IN ANY WAY