Holmes HASF2018 Operating Instructions, Adjustment Instructions, Fan Storage, Final Assembly

Final Assembly:

First, place fan head assembly onto the exten- sion pole, lining up the fan post screw with the hole in the extension pole. Then, simply insert the fan post screw into the hole and tighten until a secure fit is obtained.

Figure 6

Fan Post Screw

Screw Hole

Extension Pole

Fan Blade Cleaning:

(See instructions for fan head assembly on page 2, figure 3)

STEP 1: To access the fan blade, remove the front grill and blade cap.

STEP 2: Clean the fan blade, front and rear grills with a soft, moist cloth.

STEP 3: Replace blade, tighten blade cap, and securely fasten the front grill.

Fan Head, Base, and Pole Cleaning:

Using a soft, moist cloth, with or without a mild, soap solution, carefully clean the fan base, pole, and head. Please use caution around the motor housing area. Do not allow the motor or other electrical components to be exposed to water.

NOTE: If your fan does not have a screw hole in the extension pole but instead has an indentation around the top of the pole; please do the following:

Place the fan head assembly onto the extension pole and tighten the fan post screw until a secure fit is obtained.

OPERATING INSTRUCTIONS:

Step 1. Set fan base on a dry, level surface.

Step 2. Plug cord into any standard 120 volt AC outlet. Please make sure the Speed Control Switch is in the Off position. This switch is located on the top of the Fan Motor Housing.

Step 3. The speed is adjusted by turning the control switch to the desired setting, Off—High—Med—Low.

Step 4. The Oscillation Control Knob is located on the top of the Fan Motor Housing. To Start Oscillation, Push Knob Down. To Stop Oscillation, Pull Knob Up.

ADJUSTMENT INSTRUCTIONS:

Tilt Adjustment:

Follow these instructions to tilt the Fan Head for upward angle air movement.

Step 1: To change the tilting angle of the fan head, simply loosen the Tilt Adjustment Knob (see figure 3 on Page 2)

Step 2: Move the fan head to the desired angle, then firmly tighten the knob to lock in place.

Height Adjustment:

Follow these instructions to adjust the height of the fan.

Step 1: Turn the Base Collar (see figure 4) counter-clockwise to loosen pole.

Step 2: Adjust the pole to the desired height, and firmly tighten the Base Collar in a clockwise direction.

CLEANING/MAINTENANCE INSTRUCTIONS:

Follow these instructions to correctly and safely care for your Holmes Products stand fan. Please remember:

•Always unplug the fan before cleaning or disassembling.

•Do not allow water to drip on or enter into the fan housing.

•Be sure to use a soft cloth moistened with a mild soap solution.

•Do not use any of the following as a cleaner: gasoline, thinner, or benzine.

FAN STORAGE:

Your fan can be stored in the off-season either partially disassembled or assembled. It is important to keep it in a safe, dry location.

•If stored disassembled, we recommend using the original (or appropri- ately sized) box.

•If stored assembled or partially assembled, remember to protect the fan head from dust.

The exclusive Holmes Products FanBonnet is available to protect your fan. (See attached mail order form for special offer or call 1-800-5-HOLMES)

DETACH FROM INSTRUCTIONS AND MAIL IN THIS FORM

EXTEND THE LIFE OF

YOUR FAN

For short term or seasonal storage of your Holmes fan

FAN

BONNET

$10.99

PLUS SHIPPING

AND HANDLING

Fill out form on reverse side or call1-800-5-HOLMES

to place your order today.

Page 3