ASSEMBLY INSTRUCTIONS:
Carefully unpack contents of carton.You will need the base and four extension legs.
Figure 1
Push in the small tab on each extension and snap into base
Pole Assembly:
You will need the completed base and extension pole.
STEP 1: Remove the base collar from the base by turning
STEP 2: Take the extension pole, with the solid end down, and insert it into the base. The hollow end of the pole (with the screw hole) will be facing up.
STEP 3: Replace the base collar over the extension pole, slide it down the pole, and secure it to
Fan Head Assembly:
You are now ready to assemble the fan head (See Figure #3)
A) | Rear Grill | A | B | Figure 3 |
B) | Motor Shaft |
| ||
|
| |||
C) | Rear Grill Notches |
| C | D |
D) | Motor Housing Prongs |
|
|
|
E) | Mounting Nut |
|
|
|
F) | Fan Blade |
|
|
|
G) | Motor Shaft Pin |
|
|
|
H) | Fan Blade Cap |
|
|
|
I) | Front Grill |
|
|
|
J) | Logo Plate |
|
| G |
k) | Bottom Screw |
|
| |
|
|
| ||
|
| E | K |
|
|
| F |
|
|
|
| Fan Post Screw |
| |
|
| H |
|
|
|
| I |
| Tilt Adjustment |
|
|
| Knob | |
| J |
|
| |
|
|
|
| |
STEP 1. Position the rear grill over the motor shaft, making certain the 2 notches at the top and bottom of the rear grill fit over the 2 prongs on the motor housing. Please make sure the rear grill fits securely against the motor housing.
STEP 2. Fasten the rear grill in place using the rear grill mounting nut. Turn the nut clockwise and tighten firmly.
STEP 3. Slide the fan blade, with the hollowed interior of the blade facing towards the rear grill firmly onto the motor shaft. Make sure the motor shaft pin lines up with the recessed groove in the back of the fan blade. Also, be sure the shaft protrudes from the front of the blade.
the base by turning clockwise.
Extension
Pole
Base
STEP 4. Secure fan blade onto the motor shaft by turning the blade cap
STEP 5. Center the front grill, align- ing the Holmes logo so it is horizontal and parallel to the floor, place onto the rear grill, and snap in place. Secure by tightening the grill screw at the bot- tom of the rear grill.
Figure 4
Bottom |
| Fan Post |
| ||
Screw |
| Screw |
Base Collar
Page2
