![For Casement Windows:](/images/new-backgrounds/50714/507145x1.webp)
For Casement Windows:
For a safe fit you will need a specifically designed mounting bracket. This, and the needed hardware, can be provided to you free of charge. Installation instructions are included with the bracket. Please write to our consumer service department address, which is located at the end of this manual.
INSTALLATION GUIDE
For 24" to 27": Use up to 3" of right side, pull out extender panel
For 28" to 34": Use one 3" extender panel on the left side. Adjust the pull out extender on the right side for a tight fit (from .5" to 7").
For 35" to 37": Use two 3" extender panels on the left side. Adjust the pull out extender on the right side for a tight fit (from .5" to 7").
Larger than 37": Additional extender panels will be required.
OPERATING INSTRUCTIONS
Your fan is equipped with the technologically advanced 1Touch™ thermostat. You can set the fan from either the main housing or the remote control to run continuously in manual mode or set the 1Touch™ thermostat to your desired temperature setting. The 1Touch™ thermostat will automatically turn the fan ON or OFF depending on the preset comfort level. The comfort level ranges between 60° and 80° Fahrenheit.
•Plug the fan into a 120V AC electrical outlet
•Set the individual fan motors on either INTAKE, EXHAUST or for AIR EXCHANGE have one lever on intake and one lever on exhaust
•To start the unit and run continuously, push the button on the fan housing or on the remote control once for the High setting and press either button twice for the Low setting
NOTE: AIRFLOW DIRECTION CAN BE ALTERED WITHOUT TURNING THE FAN OFF
•To stop the unit, press and hold the button on the fan housing or on the remote control for two seconds or keep pressing the button until all the speed and temperature indicators are OFF
1 TOUCH THERMOSTAT INSTRUCTIONS
To take advantage of the 1Touch™ Thermostat, continue to press the button until the desired temperature is reached. When ambient temperature drops below the set temperature, the fan will stop. When the outside temperature rises above the set point, the fan will turn on automatically.
Note: It is normal for the fan to cycle ON and OFF as it maintains the preset temperature. To prevent the unit from cycling, you need to raise the thermostat setting.
1Touch™ has memory. The 1Touch™ thermostat will remember the pre- vious temperature setting after the unit has been turned off. However if the unit is unplugged, the 1Touch™ thermostat will be reset and will no longer remember the previous temperature setting.
REMOTE CONTROL HANDHELD UNIT
Your remote control requires 2 AAA batteries for operation. To install the batteries, simply depress the back of the remote with your thumb on the spot marked OPEN. Insert batteries according to the dia- gram shown inside. Replace Cover
•Do not mix old and new batteries.
•Do not mix alkaline, standard
CLEANING/MAINTENANCE INSTRUCTIONS
Follow these instructions to correctly and safely care for your Holmes window fan. Please remember:
•Always unplug the fan before cleaning or disassembling
•Do not allow water to drip on or into the fan motor housing
•Do not use any of the following as a cleaner: gasoline, thinner, benzine
FAN STORAGE
For all window fans, and fans that come already assembled.
•It is important to keep it in a safe, dry location
•We recommend using the original (or appropriately sized) box
•Please remember to protect the fan from dust or moisture
DETACH FROM INSTRUCTIONS AND MAIL IN THIS FORM
IT'S A GREAT IDEA!
Additional Extender Panels & Pollen Catcher™ Filters Available
EXTENDER PANELS
$9.99 (per pair)POLLEN
CATCHER™ FILTERS $12.99/per pair
INCLUDES SHIPPING
AND HANDLING
Fill out form on reverse side to place your order today.