Holmes HFH091 warranty Pre-Operatinginstructions, Operating Instructions, Setting The Thermostat

Models: HFH091

1 4
Download 4 pages 11.97 Kb
Page 3
Image 3
PRE-OPERATING INSTRUCTIONS

PRE-OPERATING INSTRUCTIONS

1.Carefully remove your heater from the box. (please save the carton for off-season storage).

2.Make sure the unit is in the OFF position before plugging the heater into the outlet.

3.Place heater on firm level surface.

4.Avoid overloading your circuit by not using other high wattage appli- ances in the same outlet. At 1500 Watts, this unit draws 12.5 Amps.

OPERATING INSTRUCTIONS

1.For heater operation, please set the Thermostat all the way to HI. (See fig. #1)

2.Slide the Selector Control to desired HI (1500W).

3.For fan-only operation, without any heat output, slide the Selector Control to the FAN setting.

4.The Power Light will remain lit during operation.

SETTING THE THERMOSTAT

1.You need to set thermostat on HI to start heater (See fig. #1). Allow heater to operate and warm up the room.

2.When the desired temperature/comfort level is reached, lower the thermostat setting until the fan/heater stops operating.

3.The control will now automatically maintain the pre-set temperature level by turning the heater ON and OFF.

Note: It is normal for the heater to cycle ON and OFF as it maintains the preset temperature. To prevent the unit from cycling, you need to raise the thermostat setting.

CLEANING/MAINTENANCE

During Season Care:

Always unplug the heater, before moving or cleaning.

1.Carefully wipe the unit with a soft, damp cloth. Please be very cau- tious near the motor and heating elements.

2.After cleaning, be sure to completely dry the unit with a cloth or towel.

After Season Care:

1.Store heater in a cool, dry location.

2.Holmes recommends that you store the unit in its original carton.

TROUBLESHOOTING

If your heater fails to operate:

Make sure the electrical outlet or circuit breaker is working.

Check for obstructions. If you find an obstruction turn the heater OFF, and UNPLUG THE UNIT. Carefully remove the obstruction and follow the reset instructions.

The thermostat might be set too low. Turn the thermostat knob clock- wise until the heater restarts.

Make sure selector is in the HI setting.

Please DO NOT attempt to open or repair the heater. Please see the Warranty for Service Instructions.

ILLUSTRATIONS

 

 

 

 

 

 

Figure

A

B

C

D

 

A. POWER LIGHT

 

 

 

 

 

B. MODE CONTROL

 

 

 

 

 

 

 

 

 

 

 

E

C. THERMOSTAT

 

 

 

 

 

D. OSCILLATION

 

 

 

 

 

 

 

 

 

 

 

 

 

SWITCH

 

 

 

 

 

 

E.

CARRY GRIP

 

 

 

 

 

 

F.

OSCILLATION

 

 

 

 

 

F

 

BASE

 

 

 

 

 

 

 

Page 3
Image 3
Holmes HFH091 warranty Pre-Operatinginstructions, Operating Instructions, Setting The Thermostat, Cleaning/Maintenance