SETTING THE THERMOSTAT
1.You need to set thermostat on HI to start heater (See fig. #1). Allow heater to operate and warm up the room.
2.When the desired temperature/comfort level is reached, lower the thermostat setting until the heater stops operating.
3.The control will now automatically maintain the
Note: It is normal for the heater to cycle ON and OFF as it maintains the preset temperature. To prevent the unit from cycling, you need to raise the thermostat setting.
CLEANING/MAINTENANCE
During Season Care:
1.Always unplug the heater before cleaning.
2.Clean the unit with a soft cloth moistened with a mild soap solution.
3.NEVER use abrasive or flammable solvents to clean the unit.
4.After cleaning, be sure to completely dry the unit with a cloth or towel.
After Season Care:
1.Store heater in a cool, dry location
2.Holmes recommends that you store the unit in its original carton.
TROUBLESHOOTING
If your heater fails to operate:
•UNPLUG THE UNIT
•Make sure the electrical outlet or circuit breaker is working.
•Check for obstructions. If you find an obstruction turn the heater OFF, and unplug the unit. Carefully remove the obstruction and follow the reset instructions.
•The temperature may be set too low. Turn the thermostat knob clockwise until the heater restarts.
•Make sure selector is in LO, MED or HI setting.
Please DO NOT attempt to open or repair the heater. Please see the Warranty for Service Instructions.
ILLUSTRATIONS
Figure 1 | OFF |
| FAN |
| LO (500W) |
| MED (1000W) |
| HI (1500W) |
| MODE CONTROL |
THERMOSTAT | SWIVEL BASE |
| |
|
|