Holmes HM1285 warranty P L a C I N G T H E F I L T E R, Replacing the Filter, Storage Instructions

Figure 3

R E P L A C I N G T H E F I L T E R

C L E A N I N G I N S T R U C T I O N S - S T O R A G E

REPLACING THE FILTER

Through normal use, waterborne minerals and sediment become trapped in the wick filter. The harder your water, the greater the amount of minerals in the water, and the more often you will need to change your filter.

You will be able to monitor the life of the filter in your humidifier by checking the Filter Check™ Indicator. When the unit is off, the Filter Check™ Indicator will read in the OFF position. After 60 minutes of use, Filter Check™ Indicator (refer to fig. 3 for close-up of indicator) will move from the OFF position

and indicate your filter condition.

A brand new filter will register in the blue section reading GOOD filter. After frequent use of your humidifier, the Filter Check™ Indicator will let you know when

the filter needs to be changed.

When the needle is in the red (CHANGE) section, this means the proper amount of moisture is not getting into your air due to the excessive minerals and sediment that have become trapped on your filter. At this point, you should replace your filter. It is important to change your filter as indicated to obtain stated performance level.

To replace the filter, follow the steps below.

1.Be sure the humidifier is switched OFF and disconnected from the electrical outlet.

2.Remove the tank and main housing to access the base tray.

3.Discard the old filter and follow weekly cleaning instructions.

4.Insert a new filter into the filter support in the base.

5.Replace the main housing and then the tank.

6.Repeat Operating Instruction steps.

It will take about 30 minutes for the humidifier to reach maximum output.

You can obtain a new filter by calling 1-800-5-HOLMES in the USA or by visiting your nearest retailer or authorized service center. This humidifier takes model HWF65 replacement filter.

STORAGE INSTRUCTIONS

If your humidifier will not be in use for two days or more, or at the end of the season follow these instructions.

1.Clean and dry the humidifier thoroughly as per the Weekly Maintenance instructions above.

2.Let the humidifier dry completely before storing. Do not store with water inside the base.

3.Do not store with the reservoir cap in place.

4.Throw away the wicking filter. Do not store with wick filter in place

5.Store in a cool dry location.

CLEANING AND MAINTENANCE INSTRUCTIONS

Humidifiers provide comfort by adding moisture to dry indoor air. To get the most of the benefit from the humidifier and avoid product failure, follow all maintenance instructions carefully. If the recommended care and maintenance guidelines are not followed, micro-organisms may be able to grow in the water within the humidifier.

Daily Maintenance

1.Before cleaning, be sure the humidifier is switched OFF and disconnected from the electrical outlet.

2.Lift off the tank and the housing of the humidifier. Remove filter and place in sink or tub as the filter will release water when not in the humidifier.

3.Carry the base and the tank to the sink, remove the wick filter, then drain and rinse the base and tank thoroughly to remove any sediment and dirt. Wipe clean and dry with a clean soft cloth or paper towel. (DO NOT use metal cleaning utensils or abrasive cleaners)

4.Put the filter back in the filter supports, replace the housing, then refill the tank with cool tap water as instructed in filling the water tank instructions.

Weekly Maintenance

Remove scale:

1.Repeat steps 1-3 above.

2.Clean the base by partially filling the base with one 8-oz cup of undiluted white vinegar, or by using Cleanse Clean™ by Holmes. Let solution stand 20 minutes, clean all interior surfaces with a soft brush.

3.Dampen a cloth with undiluted white vinegar and wipe out entire base to remove scale.

4.Rinse with clean warm water to remove scale and the white vinegar solution before beginning to disinfect the tank.

Disinfect tank:

1.Fill tank with 1/2 teaspoon of chlorine bleach and 1/2 gallon of water.

2.Let the solution stand for 20 minutes, swishing every few minutes. Wet all surfaces.

3.Empty the tank after 20 minutes, and rinse well with water until the bleach smell is gone. Dry with a clean cloth or paper towel.

4.Refill the water tank with cool water; replace the housing and the water tank. Repeat ALL Operating Instructions.