Holmes HM1285 warranty HOW Cool Mist Works, PRE-OPERATING Instructions, Operating Instructions

F E A T U R E S - O P E R A T I O N

HOW COOL MIST WORKS

Your Holmes Cool Mist humidifier draws dry air through the rear air intake grill area. This air is then passed through a moisture–laden wick filter, which retains the minerals and deposits in the water. The resulting moist air is directed back into the room from the top air grill.

NOTE: This humidification system provides a cool, invisible moisture output. It is normal not to see the mist.

NOTE: A humidity level below 20% can be unhealthy and uncomfortable. The recommended humidity level is between 40%-50%.

PRE-OPERATING INSTRUCTIONS

1.Be sure the humidifier is switched OFF and disconnected from the electrical outlet. Place on a water resistant surface.

2.Select a location for your humidifier, on a flat surface, about 4" away from the wall. Do not place your humidifier on furniture; a floor location that will not be damaged by moisture is best.

3.Remove the water tank by holding the tank handle and lifting straight upward (see figure 1).

4.Remove the main housing by lifting straight upward. Check to see that the wick filter is properly in place. Replace the humidifier housing.

FILLING THE WATER TANK

NOTE: This humidifier holds about 1 gallons of water in the tank and humidifier base. The humidifier will produce up to 3 gallons

of moisture over a 24-Hour period, depending on the room humidity and temperature.

1.Be sure the humidifier is switched OFF and disconnected from the electrical outlet.

2.Remove the tank from the base by holding the handle and lifting straight up (see figure 2).

3.Twist off the tank cap located on the bottom of the tank by turning counter clockwise and fill the water tank with cool, fresh water.

Do not fill with warm water as this may cause leaking.

4.After filling the tank, replace the tank cap by firmly turning clockwise and then replace the water tank on the base. The tank will immediately begin to empty into the base.

5.Plug the power cord into a 120V AC electrical outlet.

Figure 1	A. Circular Filter Supports
B	B. Circular Extended
	Life Filter
A	C. Humidifier Base

C

OPERATING INSTRUCTIONS

1.Turn the Power knob to the desired setting (LOW or HIGH).

2.Turn the Humidistat knob to the highest setting.

3.When the desired humidity level is reached the humidistat can be set to a lower setting to reduce the desired humidification rate.

NOTE: Allow up to 30 minutes for the filter to fully absorb water and the unit to produce the maximum moisture output.

4.When the water tank is empty and the water in the base is almost empty, you need to refill the tank. The fan will continue to run to help dry the humidifier. Switch off and unplug the unit. Please follow the Daily Cleaning instructions before refilling the water tank.

5.Refill the tank as directed in the Pre-Operating Instructions.

If you do not plan to use the humidifier for two or more days, make sure any residual water is drained from the water tank, base and wick filter to prevent algae or bacteria growth.

USING THE HUMIDISTAT

The Humidistat feature allows you to set and maintain the humidity level you wish for your room to maintain. The Humidistat setting is designed to operate between 25% and 65% relative humidity range. The recommended setting is 40-50%.

Turn the knob clockwise as far as it will turn to achieve the highest humidistat setting. In this setting, the humidifier will run constantly, and produce the greatest amount of moisture.

To lower your desired humidity level, simply turn the knob counterclockwise to choose your setting.

When the humidity in the room is less than the level you have set, the humidifier will continue to produce moisture. Once the set humidity level has been achieved, the fan will turn off. When the room humidity drops below your set level, the unit will automatically begin producing moisture again.

Depending on the size of your room and your personal comfort, you will set your humidistat at different levels. If condensation forms on your windows or walls, or your measured room humidity reads above 50% by use of a hygrometer, turn off your humidifier, or lower your Humidistat level.

A	B			H	Figure 2
				C	A. Carry Handle
		High		D
	Off		Low		B. Water Tank
	Low			E	C. Humidifier Housing
					D. 2-Speed Humidity
					Control/Power Knob
				F	E. Humidistat
					F. Filter Support
	G				G. Humidifier Base
					H. Filter Check™ Indicator