F E A T U R E S - O P E R A T I O N

HOW COOL MIST WORKS

Your Holmes Cool Mist humidifier draws dry air through the rear air intake grill area. This air is then passed through a moisture–laden wick filter, which retains the minerals and deposits in the water.

The resulting moist air is directed back into the room from the top air grill.

NOTE: This humidification system provides a cool, invisible moisture output. It is normal not to see the mist.

NOTE: A humidity level below 20% can be unhealthy and uncomfortable. The recommended humidity level is between 40%-50%.

PRE-OPERATING INSTRUCTIONS

1.Be sure the humidifier is switched OFF and disconnected from the electrical outlet.

2.Select a location for your humidifier, on a flat surface, about 4" away from the wall. Do not place your humidifier on furniture; a floor location that will not be damaged by moisture is best.

3.Remove the water tank by holding the tank handle and lifting straight upward (see figure 2).

4.Remove the main housing by lifting straight upward. Check to see that the wick filter is properly in place. Replace the humidifier housing.

FILLING THE WATER TANK

NOTE: This humidifier holds about 1 gallon of water in the tank and humidifier base. The humidifier will produce up to 2.0 gallons of moisture over a 24-Hour period, depending on the room humidity and temperature.

1.Be sure the humidifier is switched OFF and disconnected from the electrical outlet.

2.Remove the tank from the base by holding the handle and lifting straight up (see figure 2).

3.Twist off the tank cap located on the bottom of the tank by turning counter clockwise and fill the water tank with cool, fresh water.

Do not fill with warm water as this may cause leaking.

4.After filling the tank, replace the tank cap by firmly turning clockwise and then replace the water tank on the base.

The tank will immediately begin to empty into the base.

5.Plug the power cord into a 120V AC electrical outlet.

OPERATING INSTRUCTIONS

1.Move the Humidity Control Knob to the HI position. Move the Humidity Control knob to the LO setting to lower the humidification rate. Allow up to 30 minutes for the filter to fully absorb water and the unit to produce the maximum moisture output.

NOTE: We recommend the use of the hygrometer which you can purchase by calling 1-800-5-HOLMES. A humidity level below 20% can be unhealthy and uncomfortable. The recommended humidity level is between 40% and 50%.

2.When the water tank is empty, and the base is almost empty, you need to refill the tank. The fan will continue to run to help dry the humidifier. Shut off and unplug the unit. Please follow the Daily Cleaning Instructions. Refill the tank as directed in Pre-operating Instructions.

3.Make sure the unit is switched OFF, then plug into the electrical outlet. Turn the power ON.

If you do not plan to use the humidifier for two or more days, make sure any residual water is drained from the water tank, base and wick filter to prevent algae or bacteria growth.

Figure 1

 

A. Circular Filter

 

 

Supports

 

 

B

 

 

B. Circular

 

A

Extended Life

 

Filter

 

 

 

 

C. Humidifier

 

 

Base

C

A

F

Figure 2

 

C

 

B

 

A. Carry Handle

 

 

B. Humidifier Tank

 

D

C. Humidifier Housing

 

 

D. 2-Speed Humidity

 

 

Control/Power Knob

 

 

E. Humidifier Base

 

E

F. Filter Check™

 

Indicator

 

 

 

 

 

Page 3
Image 3
Holmes HM1700 warranty HOW Cool Mist Works, PRE-OPERATING Instructions, Operating Instructions