REPLACING THE FILTER
REPLACEMENT OF HOLMES® EXTENDED LIFE FILTERS:
Through normal use, waterborne minerals and sediment become trapped
in the wick filter. The harder your water, the greater the amount of minerals in the water, and the more often you will need to change your filter.
You will be able to monitor the life of the filter in your humidifier by checking the Filter Check™ Indicator. When the unit is off, the Filter Check™ Indicator will read in the OFF position. After 60 minutes of use, Filter Check™ Indicator (refer to figure 5
for close-up of indicator) will move
from the OFF position and indicate your filter condition. A brand new filter will register in the blue section
reading GOOD filter. After frequent use of your humidifier, the Filter Check™ Indicator will let you know
when the filter needs to be changed.
When the needle is in the red (CHANGE) section, this means the proper amount of moisture is not getting into your air due to the excessive minerals and sediment that have become trapped on your filter. At this point, you should replace your filter. It is important to change your filter as indicated to obtain stated performance level.
TO REPLACE THE FILTER:
1.Push the MODE/OFF button for 2 seconds to turn the unit off and unplug the humidifier. Lift off the housing of the unit, remove the used wick filter, and throw it away.
2.Remove the protective bag from the new wick filter and slide the filter down into the circular filter support in the base. Replace the housing, refill the tanks, plug the cord into the electrical outlet and press the MODE/OFF button to turn the unit on. Because the filter needs to absorb water to function properly, it will take about 30 minutes for the humidifier to reach the maximum moisture output (see figure 3).
NOTE: You can purchase replacement filters (model HWF75) at a local retailer, by calling 1-800-5-HOLMES, or by visiting www.holmesproducts.com. Please refer to the replacement Accessories section at the end of this manual. It is recommended that a replacement filter is purchased for uninterrupted use.
Figure 4
A. CIRCULAR EXTENDED | | |
LIFE FILTER | | A |
B. CIRCULAR FILTER | C | B |
SUPPORT | | |
C. FLOAT SWITCH | D | |
D. HUMIDIFIER BASE | | |
CLEANING AND MAINTENANCE INSTRUCTIONS
Humidifiers provide comfort by adding moisture to dry, heated indoor air. To benefit most from the humidifier and avoid product misuse, follow all instructions carefully. Please note that this is an electrical appliance and requires attention when in use.
In addition, if you do not follow the recommended care and maintenance guidelines, micro-organisms may be able to grow in the water within the Water Tank. You must routinely follow the cleaning procedures that follow in order to ensure proper, efficient operation of your humidifier. Proper maintenance and cleaning is essential to the continued performance of your unit and the avoidance of algae or bacteria build-up.
DAILY MAINTENANCE
1.Before cleaning, be sure the humidifier is OFF and disconnected from the electrical outlet.
2.Remove the housing and the tanks from the humidifier and place them in sink or tub.
3.Carry the base of the unit to the sink, remove the wick filter, drain any remaining water and rinse thoroughly to remove any sediment or dirt. Wipe clean, and dry with a clean cloth or paper towel.
4.Drain the water from the tanks into the sink and rinse each tank thoroughly. Wipe clean, and dry with a clean cloth or paper towel.
5.Put filter back in the filter supports, replace the housing, then refill the tanks with cool tap water as instructed earlier in the Filling Instructions. Do not overfill.
6.Follow Operating Instructions.
WEEKLY MAINTENANCE
To Remove Scale:
1.Repeat steps 1-4 above.
2.Partially fill the base with Holmes Cleanse Clean™ (Model S1710) as instructed on bottle, or with two 8 oz. cups of undiluted white vinegar. Leave this solution in the base for 20 minutes, while cleaning all interior surfaces with a soft brush. Remove base scale by wiping the base with a cloth dampened with undiluted white vinegar.
3.Rinse with clean warm water to remove the cleaning solution before disinfecting the tank.
To Disinfect Humidifier Base and Tanks:
1.Fill Humidifier Base with 2 gallons of water and 1 teaspoon of chlorine bleach.
2.Fill each tank with .5 gallon of water and 1 teaspoon of chlorine bleach.
3.Let the solution stand for 20 minutes, swishing every few minutes. Wet all surfaces.
4.Carefully empty the Base and Tanks after 20 minutes, and rinse with water until you cannot detect any bleach smell. Dry with a clean cloth or paper towel.
5.Check the Filter Check™ Indicator to see if it is time to replace the filter. Depending on the water hardness in your area, it may be necessary to change the filter every 1-2 months. Re-insert the wick filter into the filter support.
6.Refill the water tanks as directed with cool tap water, replace the humidifier housing, and turn the Control Knob to ON.
