5 Operating the Remote

5.1 Normal Operation

Once you have setup the remote for your A/V equipment, it works like your original remote controls. To operate, just aim it at your equipment, press an appropriate device mode key and invoke the desired function by pressing a corresponding key on the remote. The indicator flashes and you can hear beep sound during signal transmission as confirmation of key touch.

5.2 Page

Each device mode contains 3 groups of commands. You can simply tap the “ Page ” key on the right bottom corner

of the remote panel to turn to another command group.

5.3 Shift

By pressing “ ” key followed by one of the hard key, you can control the following function for your TVs.

CH+

Brightness up

CH–

Brightness down

VOL+

Colour up

VOL–

Colour down

5.4 Punch Through

Punch through allows you to operate TV’s volume and mute functions without having to switch the device modes repeatedly even when your remote is in other operating modes.

However, if you have learned commands on VOL+, VOL–

or in the device mode (VCR, DVD, SAT, CTV or AUX), the punch through function will be disabled in that corresponding device mode.

5.5 Advanced Function – Smart Program

Create a chain of multiple commands – your remote comes

with 3 programmable Smart programs ( , , ) each with maximum 15 key steps. With the help of Smart, you can program a group of commands in time

delay to execute in a chain of infra-red signal simply by a press of Smart.

9

6 Program a Smart

1.Hold down “ CH+ ” & “ VOL– ” on the HTMR simultaneously for 2 seconds until the indicator lights up.

2.Enter the Magic Code – 0009.

3.The Smart icons will flash.

4.Select a desired Smart key. (e.g. )

5.Select a command from the corresponding device mode and indicator will flash once for each key.

6.Repeat step 5 until you finish the whole program and press

the same Smart key (e.g.). The Smart program is stored.

7.To program another Smart, repeat the steps 1 to 6 above.

6.1Operating a Smart Program

1.Aim your remote at the equipment.

2.Press and release the Smart key that you have

programmed (e.g.). The corresponding Smart icon and the indicator will flash slowly during transmission of the signals. The Smart icon and the indicator will stop flashing when the chain of infra-red signals has been transmitted completely.The remote will go back to normal.

7 Maintenance

–Do not expose your HTMR to dust, strong sunlight, humidity, high temperature or mechanical shock.

–Do not use old and new batteries together as old batteries tend to leak.

–Do not use corrosive or abrasive cleansers on your HTMR.

–Keep the unit dust free by wiping it with a soft, dry cloth.

–Do not disassemble your HTMR, it contains no user-serviceable parts.

8 Troubleshooting

Q.My remote does not work all !!!

A.Check your A/V device, if the main switch of the device is turned off, your remote could not operate it.

A.Check whether your batteries are inserted properly and are in correct +/– marks.

A.If the batteries are weak, replace the batteries. See “ 1.4 How to Install Batteries ”.

Q.If several device codes listed under the brand of my A/V device, how can I select the correct device code?

A.To seek the correct device code for your A/V device, test the code one by one until most keys work properly.

10